Jose, Most USA marinas and some Caribbean have 30 and 50 amp not 60 outlets. They are not 3 phase. The 50 amp have 4 wires on the plug, green-Ground, black and red hot, and white neutral, Between the

Bertrand, In most of the american continent, mono(single) phase AC current runs at 110 V 60 Hz with one cable life and the second neutral relative to ground. Thera are 30 amps and 60 amp outlets.

Hi Bertrand, Many Amel’s use the 50 amp plug, mine included for over 19 years. You need a 50 amp twist lock plug. You do not use the neutral wire connection. In the USA it is white in the

 Thanks for your replies, I agree most of marinas in the 120 V zone are able to provide 240 V 60Hz. This is what we got so far during our tour. However here in Quepos marina when asking for it here

In case you missed it, the following was posted in September by Amel at https://amel.fr/en/fraudulent-communication-by-email/ Dear Customers, Dear Partners, We inform you that fraudulent emails are

Scott, Incidence Sails, the OEM manufacturer for Amel has issued special pricing for 3 qualities of sails for Super Maramus, 54s, and 55s. I negotiated the special pricing for my clients, and in a

By the way, Trans-Ocean e.V. is open to everyone. The annual membership fee is 90 euros. So a membership can be well worth. ,-)

Scott, all sails are made of different laminates. Main 44.2 m²: 40% Polyester Sandwich DCX-L 320 g/m² 20% Dyneema DYS-14 Offshore 435 g/m² 40% Dyneema DYS-23 Offshore 450 g/m² Mizzen 25,0 m²: 40%

Hello Joerg again, installing the tack is going to be a challenge too, but you could try to install an eye-bolt on the dodger. Originally, the main sheet tackle was installed there. Cheers. Olivier.

Hello Joerg, the AMEL 55 mizzen mast is not designed to bear a mizzen staysail: -the front halyard is going out of the mast with a fixed sheave. If you use it as a mizzen staysail halyard, it will

Let me point out that Elvstrom Sails, who make the sails for Halberg Rassy, has been making these sails with the long battens for what seems like a decade. All HRs with furling Mains seem the have

Happy New Year everyone! The original sailplan for the 55 does not include a mizzen staysail but the standard spec includes 2 spare halyards on the mizzen, one running forward from the top of the

Just a shot in the dark, but could it be an AC circuit breaker failing? Try either replacing them or, to diagnose, temporarily hard wire across them and see if it holds. -- Craig Briggs - s/v

Hi Giorgio Thank you. I have the same tool (4) but finally now after many years I know what it is for. -- Gerhard Mueller Amel Sharki #60 Currently North Sea, Germany

Hi Ben 4) It is a tool for fixing the table in the cockpit. It attaches to the wheelhouse seat and locks the table. At least on my Sharki, but I think it's the same on the Maramu. Greetings Giorgio

Dear Ben, Your maramu is in some respects similar to our contemporary mango: 1. It is cable steering 2. I think that might be possible, but you can also install a second one near the neco (that was

Hey all, it's been a while.... hoping y'all are doing great! And hoping someone has some knowledge of my generator problem. It's an old (30 y/0) Onan 6500 marine genset in my amel super maramu.

Sorry, of course, I meant the cost for the fully battened main and mizzen. Then the Genoa. I presume by "jib", you mean staysail? -- Scott 2007 A54 #69 SV Tengah http://www.svtengah.com

Martin, How much did it cost for your fully battened main, Genoa and mizzen? Is it hydranet? -- Scott 2007 A54 #69 SV Tengah http://www.svtengah.com

Our boat is 230v but we spent some time in 120v land. We do not have an isolation transformer. We don't spend a lot of time in marinas, but we found that most of them in 120v land had a pedestal with