An Amel-owner told me that using the "Trinkette", or staysail, on a SM gains 5-6 degrees of upwind performance. Can anyone verify this claim? Paul C. still looking

Jeff, Where is the test lever for bilge alarm? Peter Forbes Carango Bermuda

I think the positioning of my bilge alarm is good. I checked mine recently by removing and tipping upside down and found malfunction due to corroded wiring which I corrected and now all OK. I agree

Hi Jeff, the comments were on this forum a few months ago, probably directed at wind generators in general but he had a D 400 he would have been pleased to dispose of. I did wonder if there was

Sorry wrong subject David, I had the genoa furler serviced by Amel in Martinique in November. The gears were fine however they replaced 5 bearings and 9 seals or the other way around. They

David, I had the genoa furler serviced by Amel in Martinique in November. The gears were fine however they replaced 5 bearings and 9 seals or the other way around. They also replaced the electrical

Hi Jeff, Weight: Superwind 11.5 kg D 400 17 kg or 33% heavier. At the top of a mast that is significant. Output. Superwind is rated for 350 watts and the D400 400 watts. I have been happy with the

Hi all, Today's maintenance task was testing the bilge alarm. We had heard recently of at least one 54 owner who found out the hard way it didn't work. So it was high on the list and, sure enough, the

HI Jeff, Correction: SPEEDWIND should read SUPERWIND. Best Regards Teun Apr 08, 2018 07:31:44

Hi Jeff, The top of the Mizzen has a flat plate on it that extends beyond the extrusion. When we bought Ocean Pearl it had a hole at each corner. We made the mast for the wind generator with a

David, I had the genoa furler serviced by Amel in Martinique in November. The gears were fine however they replaced 5 bearings and 9 seals or the other way around. They also replaced the electrical

Thank you Bill Skickat från min iPhone 7 apr. 2018 kl. 19:44 skrev greatketch@... [amelyachtowners] <amelyachtowners@...>:

Thank you very much Eric /Niklas Skickat från min iPhone 7 apr. 2018 kl. 19:29 skrev 'sailormon' kimberlite@... [amelyachtowners] <amelyachtowners@...>:

56 inches of chain would be enough for my installation. That would give a little bit extra to be sure as Eric suggests. Of course, that assumes your installation is exactly the same as mine. Bill

Niklas, You just buy a length of chain a little longer than you think you need and a master (removable link). You then drape the chain over the sprockets and mark it to the length needed. Remove

Hi Porter, Sorry - dropped by, but missed you. Hope things are going well in Martinique. Our standing rigging has arrived - finally. If was made-up and shipped by ACMO in good time, but we opted to

Hello Is there any that knows the length of the chain for the autopilot (rotary drive) Niklas SY Nipe SM2K#333