Thanks Bill Yes They definitely got it wrong in Martinique. Fair Winds Eric Kimberlite Amel Super Maramu #376

Jason Rutledge recently had copies made of the Leroy Somer Bronze gear in Leroy Somer Gearboxes. If interested, here are the details: Leroy Somer Bronze Gear Made in Houston, Texas.pdf CW Bill Rouse

Neil, we found that the creaking was coming from the boom sheave. But why? After a close look we found that the out-haul line was too stretchy and the sheave was facilitating that. There is always

Thanks Bill for the info as always - and thanks Scott for reassuring me that this is not likely to go away any time soon! I’ll certainly have a go at cleaning and lubricating the sheaves but just

I think it’s happening much more quickly than you

Nick Please get in touch with Dott.ssa Chiara Fruzza from Gianneschi. She is very helpful (and a Doctor btw); - I explained what kind of pumps (Climma and Fresh Water pump) I have on Board and she

Hi Scott, In common with many SM owners we found ourselves having to clean the aft waterline too often. After studying a variety of waterlines on different yachts we took the plunge when we put

Thank you Bill, Nick, Mohamad et all, I agree with your comments and I was somehow sure not to support the boat on the hull solely without support on the keel. But the yard asked because it’s

Hi David, About 10 years ago we switched to an ordinary Jabsco model. Slightly noisier, more powerful ( we don't have showering teenagers on board ! ) . Cheaper than the original Amel pump. We carry

Thank you David, I will keep the boat in the travel lift slings. Cheers, Ruedi Von: "main@AmelYachtOwners.groups.io" <main@AmelYachtOwners.groups.io> im Auftrag von David Dickman

Hi Scott, How do you find the flow rate with the UP6/E compared to the original pump? Kind regards Nick

We were fed up with the growth under the stern and the ‘skirt’ of weed on the boot stripe. We re Coppercoated this winter and had it taken up to the cover the whole red boot stripe. It has worked

Maybe this helps you: CW Bill Rouse Amel Owners Yacht School +1 832-380-4970 | brouse@... 720 Winnie, Galveston Island, Texas 77550 www.AmelOwnersYachtSchool.com Bio & References Create

I do not need to now how the motor is taken apart. I believe that they put the foil in the furler 180 degrees out of sync with the motor. I need to know how the foil sits in the furler—in other

Hi all, Faced with limited availability (and time) at the moment we needed to replace the already non-OEM freshwater pump, I elected to go for a generic electronically-controlled variable-speed

re the pressure vessel.... When I orginally installed the Marco pump I didn't include a pressure vessel. The pump cycled off and on, I asked Marco and they suggested adding a small pressure vessel.

Cheers Neil good luck

Hi Scott, my 2c. Why not raise it to one of red stripes? If you try to make the waterline even, then later If the boat is balanced again, the water line will become crooked. To me uneven bottom paint

We have raised the boot stripe on Nebo, we have a list as per normal. I went with 3 inches of antifoul showing, the raising started at the forward lowers. We then went with a lithium battery bank.

Hello Nick, I installed a 12A on my SM007 (Eleuthera) when the previous pump went AWOL. I also removed the pressure vessel and added about 1.5 meter hose as per Marco’s instructions and this was