Maybe this helps you: CW Bill Rouse Amel Owners Yacht School +1 832-380-4970 | brouse@... 720 Winnie, Galveston Island, Texas 77550 www.AmelOwnersYachtSchool.com Bio & References Create

I do not need to now how the motor is taken apart. I believe that they put the foil in the furler 180 degrees out of sync with the motor. I need to know how the foil sits in the furler—in other

Hi all, Faced with limited availability (and time) at the moment we needed to replace the already non-OEM freshwater pump, I elected to go for a generic electronically-controlled variable-speed

re the pressure vessel.... When I orginally installed the Marco pump I didn't include a pressure vessel. The pump cycled off and on, I asked Marco and they suggested adding a small pressure vessel.

Cheers Neil good luck

Hi Scott, my 2c. Why not raise it to one of red stripes? If you try to make the waterline even, then later If the boat is balanced again, the water line will become crooked. To me uneven bottom paint

We have raised the boot stripe on Nebo, we have a list as per normal. I went with 3 inches of antifoul showing, the raising started at the forward lowers. We then went with a lithium battery bank.

Hello Nick, I installed a 12A on my SM007 (Eleuthera) when the previous pump went AWOL. I also removed the pressure vessel and added about 1.5 meter hose as per Marco’s instructions and this was

Marco recommends an accumulator tank if the vessel's plumbing is rigid like the PEX in Amel 54s and later. For a SM with hoses the accumulator tank is not needed. Best, CW Bill Rouse Amel Owners

After nearly 5 years of scrubbing growth off our gelcoat in beautiful tropical locations, we've given up and decided to raise the waterline. As with many Amels, we are a bit stern heavy, accentuated

Have any of you replaced fuel injectors on your Volvo D3-110C? Did you need to code it with a Vodia tool? The diesel injector mechanic seems to believe so but the Volvo dealer is

Has anyone replaced these sheaves? I have probably dumped a liter of lube (one drop, grease, everything slippery I can find on the boat) over the last two years and the noise goes away for a short

Hi Nick, We changed our original FW pump out for a Marco UP14/E about 6 years ago and it is the best FW pump I've ever had.The flow is variable according to demand and it keeps up with multiple

Hawaiian Airlines is supposed to offer it for free on flights from California to Hawaii in 2023. My admittedly old electronic charts shows an ocean between those two locations.

Thanks Wolfgang for the information. Predictwind is a very attractive solution but for those already equiped with a non Predictwind SIM activating the GPS tracking requires a professional subsription

Nick, I installed the Marco UP/6E without a pressure vessel at first. I would not recommend that. Because of our freshwater heads, there's an issue called the "hammer effect" when the toilet water

Nick, The A.F.M.A., Reya, and other manufacturers of the 66B and 88b Freshwater pumps use the same kit for the 66 and 88. I know that there are at least 50 of these kits aboard boats that purchased

Ruedi I would not want to chock the boat with the keel free. Too scary, too much potential point loading on the hull….. I would do the job in two hits. Use 30cm thick wood blocks rather than 15cm

I have not had any luck sourcing the spares kit for the original AMFA freshwater pressure pump. IMNASA have no stock. So much for my faith that the impeller would last forever with only freshwater

The other option would be to place the support under the keel in an area where you do not need to make as much repair then when it’s done, you can move the support and do the remaining area