Hi Paul. Previously a client and now a friend, Mark on CREAMPUFF might not have noticed that you have an Amel 54 and not a Super Maramu 53. The bow thrusters on these boats are entirely different from

Bill Kinney helpfully posted an Amel Vector Logo file in photoshop format. I don't have photoshop software so coverted it to .jpg format and posted it, too. The original file Bill posted had an

Yes it is possible to remove the assembly while in the water usingthe special Amel tool – there is a file on this in the FILES section written byGary Silver and Bill Rouse With bestregards,

Hi all, My sidepower bowthruster has lost the linkage to the props and just spins. According to the manual a probable cause could be rope getting sucked in which causes the "flexible coupling" to

Hello, The upper furler bearings for my Genoa, Main and Mizzen seem a little stiff. I washed them out with warm soapy water which helped but they still feel a bit too stiff to me. Can anyone

Hi Porter I am heading to Martinique on Saturday I'm in Marin on the fuel dock Look me up if you have a chance Courtney Trippin' Marin

Thank you everyone for helpful comments. Just to close this post off, we can report that Amel have been extremely helpful to us. They did not have any SM53 bowthruster units in stock, but given our

David! Hello. We’re over in the IWW Marina. Provisioning and deciding on new sails. Looks like you’re wearing out your Visa card!! Went to FKG yesterday. Looks like a serious outfit!! What wind

David, I was looking at the DX900+, which does depth and speed as well but is electromagnetic. I finally called Airmar and talked to them about it, and the gentleman told me it would not fit in the

Hi Porter, Where are you? We are in anchored the lagoon, Dutch side, awaiting our standing rigging, which we are doing with FKG. Plus a host of other projects kicking in while the masts will be

Hi John, Lagoonies was, in essence, undamaged. The machine shop behind Lagoonies is up and running, as is the sail loft above. Cheers, David Perigee, SM#396 Sint Maarten

Greetings Duane, I used the Airmar DST800 NMEA2000 version, plastic; it was a direct drop-in replacement for existing depth-sensor (located in bilge outside the FWD head). Downside: paddle wheel =

Shelter Bay Marina across from Colon, Panama is a well-run facility that can haul an SM. Kent S/V Kristy karkauai@...

I’m here now and will have a look John. And agree with David. This place is amazing! They have everything! Porter. Excuse the errors. Sent from my IPhone Www.fouribis.com

Thanks James. I'll try her Kind regards Danny SM 299 Ocean Pearl

Thanks Craig, I'll try her. Kind Regards Danny SM 299 Ocean Pearl

Thanks Alan, Northland Spars and rigging in Opua have done satisfactory work for me in the past. I am just canvasing the options and the Acmo one appeals if the price is right. Kind

David, Which depth speed temp sensor did you install? I'm doing the exact same project right now. Just finished another day of chasing down wiring! Duane Wanderer, SM#477

David, Which depth speed temp sensor did you install? I'm doing the exact same project right now. Just finished another day of chasing down wiring! Duane Wanderer, SM#477

Hi David, thanks for the update. We are headed that way....slowly taking our time though the Bahamas at the moment. By any chance would you know the status of the machine shop behind Lagoonies?