Bill Can you make a recommendation as to what to get? No implied liability of course! Thank you as always! Porter Excuse the errors. Sent from my IPhone Www.fouribis.com On Jul 19, 2017, at

I believe that the Calpeda pump may be slightly underrated when all 3 compressors are cycling ON...AND, the March pump that Ben installed is slightly less than the Calpeda pump. However, in my

Mark, My March pump puts out 951 GPH @50 hz. True, this is less than Calpeda. I loosely used Bill Rouse's formula of 1 GPM for every 4,000 BTU which says I need min 405 GPH. I have more than double

I’m not sure that the AC model has sufficient flow ratings whencompared to the TE model. Keep in mind that when plugged into 50 Hz the pumpoperates about 10% lower. The TE model more closely matched

Thank you Bob We will make an over night stop at Sandy Hook, before proceeding towards Ellis Island Paul on SY Kerpa SM 259

Oliver We paid slightly less than $300 on eBay. It was an easy switch from Italian pump. Ben Hi Ben - Thank you for purchasing as an eBay Guest. We will update you when your order ships to 2545 S

Hi Oliver We replaced original pump with March. It cost much less than Italian pump and has an excellent reputation. See below Ben March pump AC-5C-MD 230v 1020 gph Replacement pump for

Hi Paul There are 3 anchorage areas near the Statue of Liberty--1) west of Liberty Island before the Liberty State Park boat ramp, Latitude: 40°41.746'N Longitude: 074°03.835'W 2) behind Liberty

I am an electrical engineer, but of course .... sometimes the advice is worth exactly what you pay for it.... The person the wrote that the wrote that the current will be less if operating at 220V

Oliver, We replaced the expensive Italian Calpeda pump installedby Amel with this: https://www.coastalclimatecontrol.com/index.php/product-catalog/product/260-march-1500-gph-115-230v.html.It works

Hi everybody! We have the original Calpeda BCM20E AC pump on board of our 13 year old SM 2000. We would like to buy a spare pump as long as the boat is in the US, where it is easy and cheaper to

Jay, Many of your questions I do not feel I have the data to comment on with authority, but I will toss out a few nuggets. I would be very uncomfortable with the idea of carrying a spinnaker with the

Hi Amel Owners, First off, thank you for all of the knowledge and boat parts you all have provided. Your generosity has been overwhelming. As previously mentioned, as I am preparing to go cruising,

Absolutely correct Gary! Some of the US 110VAC power strips have electronics inside which are vulnerable to 230VAC 50htz. This issue is that Duane, or anyone else trying this risky substitute for the

As per the Feit website, the S40 pump is rated for pressures to 2 bar (about 30 PSI). Several people have used these pumps with nozzles to get anything more stubborn than sand off the chain. These

Paul , If you keep it on the hard , Skipjack is very clean , boats stored on a blacktop surface , approx $1700.00 haul / storage /launch . Stored in water Georgetown Marina , slip with bubbler $850.

If the power strip has surge protection it will fry with the 230v (I think). I did have one power strip smoke off, without any load, aboard already so I don't have them any more. We do have an

Thank you Stepehen, our first stop will probably be behind statue of Liberty, then we see. Would like to meet you too, but think we will mot leave south Manhatan that soon Paul

Paul, Unless you are hell bent on Huntington, you can anchor in Oyetr Bay, the harbor just before Huntington. As you enter or Long Island Sound you will enter Cold Sprin Harbor if you go directly

Eric Thank you Paul