I have had serious problems with the outhaul motor. It has been previously repaired and the wire/ brush holder connection is not good. I've previously taken it apart on deck to resolder the wires as

Hello, is this the gear that turns the rotary action of the motor into the pistoning action the pump needs? Regards, Peregrinus SM2K #350 At anchor, Olbia ---In amelyachtowners@..., <seagasm@...>

Have a read of this : Sea Hawk Paints executives get prison terms in banned-coating case Sea Hawk Paints executives get prison terms in banned-... Toggle

I have discovered the nylon gear cog on the main bilge pump has broken. This causes the gear to slip when engaged. Ideally I would ike to replace this gear wheel however, I am not getting any response

We've had Seahawk Cukote (Brown - 3432) since September 2012. Two coats plus a bit of reinforcement at the waterline. Lasted in quite nice condition until February 2015, when two additional coats

The AMFA 66B is a fresh water pump. Bill Rouse BeBe Amel 53 #387 Sent from my tablet +1832-380-4970 USA Voice Mail

Whoa, Seahawk in Fl still making great paint. Some tin paints like Seahawk 44 is Only sold outside the USA. It has lasted 4 years in the islands (hauled 4 months/yr). Works in Annapolis (brackish)

Ian, I bought Velox , maybe it is not the same . It also may not work in fresh water , that we have here on the Sassafras River. Pat SM #123

I also need to replace my FEIT Bilge pump. Is the concensus that it should be replaced with the model AMFA 66B 24v or PVM 0.16 with 26 L/m? Has anyone used a larger capacity model that fits? John

Hi Pat, In my case, it was done by a very good yard and I was doing a service on the engines at the time and monitored their process. It was done as you stated but it has vanished in less than 10

Mine is Velox --------------------------------------------

Is your prop anti fouling Velox or Velux. Mine is Velux which I got in the Med. I am still using it and have never had any problem. Just wondering if it is a totally different product? Ian Ocean

Velox has work very well for over a year for me. But one month after arriving in San Juan, the propeller was covered of Barnacle… My neighbors explained to me it is notorious here, apparently due

Jean-Pierre, Mine did not vanish, the prop is still fully coated with paint. I completely sanded the prop, applied two coats of primer and three coats of paint . My problem is that it did not work, I

Hello Pat, I have the same problem regarding the Velox… less than 10 hours after application, it had vanished…. Jean-Pierre Germain, SY Eleuthera, Amel Super Maramu 007

Duane, If your boat is in fresh or brackish water and will remain in it for more than a day or so before going into salt water , make sure the paint you select is compatible with fresh water. Some

Good morning Duane, I have only own my vessel for 4 years, but at each haul out I had 2 coats put on, plus a 3rd at the water line. Last time, March 2015, I actually had put 2 different colors:

We're not in the Caribbean but in the Pacific. We used Seahawk Cukote in 2014 before heading to Tahiti, it seemed to be OK until we arrived in New Zealand. After 3 months in the marina at gulf harbour

Duane, CuKote is an ablative paint. It is a bit simplistic to say with that kind of paint the more you put on the longer it lasts, but that is pretty much true. A second coat of paint is not a big

I'd like your opinion on how many coats of bottom paint to use. We plan on heading into the eastern Caribbean on November 1 and we plan on pulling the boat now for bottom paint, C-Drive, prop and bow