I'm not surprised that you could not find this exact alternator in the US. I had the same issue but I was able to have a local alternator shop review the specifications of the alternator I needed and

Hi again Alex, I just installed a new Victron Skylla-i 24v 80A (1+1) charger. It has an automatic equalization OR manual equalization mode that can be set for your batteries' requirements. I only

Thanks Peregrinus, I'm looking for the "zincs", too. So far no luck but waiting to hear from QuickUSA. Kent SM243 Kristy

Jeff, I cannot answer all of your questions regarding the Bamar electric furler, but 2 wires would work fine if the relay and solenoids reversed polarity to reverse the motor. I suspect that is how

Hi again, Vladimir, I wrote my first post before I read your second post. It definitely sounds like you have removed the flange first and then tried to install the sleeve. You must leave the flanges

I recently swapped out my headsail boxtron unit with my staysail boxtron unit. I am replacing the staysail boxtron unit with the new boxtron e14s unit. Besides the conversion of the +/- power cables

Hi Vladimir, It sounds like the issue is that you are trying to push on the edge of the sleeve, which is incorrect. You must only push on the flange, never on the edge of the sleeve. No special tools

Hello Bill, I changed my Battery charger 2.5 years ago, using MDP (they say they purchased Dolphin) and they don't offer that Sulphation recovery Program But looking at the owner manual of the

Danny and Alex, Danny has a later model of Dolphin charger than Alex dies and Danny's Dolphin charger is a latter model than what was originally installed on Danny's SM. Alex, I am fairly certain

Good morning Danny, I just compare the Dolphin owner manual and my new MDP, unfortunately I won’t have the Sulphation recovery Program like you have… Very interesting curve. Also thanks for the

Bill, Creg, Please explain how did you push on a sleeve after you removed a flange. SKF instructions state that you have to push on a flange. Vladimir SM #345 "LIFE IS GOOD"

Kent, The electric element on our Quick B3 40L has one long "u" resistance and one long sleeve for the thermostat. These parts are about equally long. The element came with an installed zinc,

I remember to have read here some time ago of a way to remove the slider without removing the dodger. Somehow it seems to be possible to open the tracks and get the slider out. Cannot remember

Eric, Many thanks for sending the photos. Not having to remove the hardtop will save me a lot of time. Best, James Alton SV Sueno, Maramu #220 Arbatax, Italy

Vladimir, I think you will find that several people have installed speedi-sleeves on an Amel “wearing-out-bearing” without issue. Some people have had good luck with them, getting longer life than

Vladimir I had no problem installing the sleeves. I did not need any special tools. Fair Winds Eric Kimberlite Amel Super Maramu #376

Thank you Herbert, I searched this couldnt find in usa. Fair winds. Nezih Mahayana Maramu81