We need to replace the wind instruments and its equipment at the mast head. Linking a new wind direction and speed sensor at the top of the main mast to a B&G Zeus2 screen in the cockpit requires a

Thank you very helpful. pjp

Hello Steve, I don’t have the 2 with the rings at the end… I would have guessed the 2 with the U shape would have been to go on the part just mentioned on the mizzen shroud, but 6’ long

Can't help you with the details of the cover, we don't have that one! You'll also need someone else on those other bits, they are not on my boat. Bill

I am looking for an Amel SM. I will need a surveyor. Is there anyone who is particularly recommended in Portugal? Thank you

Thank you Bill. Was this an original Amel cover I assume. I don't think I have seen any hint of that on board though if someone has a picture, or a link to some, I'd be curios to see what this cover

I had to ask the same question. It's to support a pole for a cover. If you don't have the cover, it's not needed. On Nov 22, 2016, at 14:20, Stephen MORRISON steve_morrison@... [amelyachtowners]

As a new SM owner (2003 #380) looking into replacing the standing rigging, I can't figure out the function of the swage fitting (ring a couple feet up) on the mizzenmast shrouds. Can anyone explain

Be sure to add a fan in the engine room too. Bali Hai SN24 Ric Gottschalk Kitchen Magic Refacers, Inc Office 410-923-5800 Fax 410-923-5802 On Nov 22, 2016, at 9:49 AM, sangaris@... [amelyachtowners]

Jim, As you look at fans, include Caframo. We have 4 and they are excellent - quiet, 2 speed, movable or fixed. Also, we went 4 years on our Santorin without air, never a problem in trade winds. Then

I once had the watermaker running on a passage in a 7-10 ft sea. We were on a starbord tack heeled 12-15degrees. When I went off my watch I told the next guy to watch the gauge and turn the

Bill I will inspect closely. If it looks dangerous I will close valve and isolate the manifold Steve, I sent an email to Kilkea II. Looking forward to his reply Ben Driver La Bella Vita SM #347

Graham. Yes, when we first got the boat I overfilled the tanks. The water maker fed in through the inspection panel below the sink, and as this wasn't a sealed connection I think the overflow came

Hi Ben, When we were at Le Marin last spring, we met a fellow with an SM2000 who had a new stainless manifold fabricated by someone there. If I remember correctly, he paid in the 300 euro range for

Hi again Bob, This is the link with part number and description for the switch with RS. I think that they ship Worldwide. 2238681MOM PUSHBUTTON SWITCH - BLUE 1NO+1NC Your part numbers : Cost Centre

Hi Bob, You can get the limit switches from Amel, or online with RS in the UK. I just replaced mine, got them from Sonja at Amel Hyeres. My problem was actually not just the switches, the connections

Bill, I think that you are making a very important point. If the tank were accidentally pressurized to only 10 PSI (City water pressure I believe is usually around 40, so this would actually be

Ben, Be careful… that leak might be evidence of significant weakening of the part. It would not make for a good day if you were offshore and a branch of the manifold broke off. Bill Kinney SM

Recently there were several forum comments on salt water manifolds. Specifically, concerns about failures on older boats. Today mine failed - actually just sprung a leak. As I will be at Amel

Thanks Kent. A very helpful data point! Harmoinie's previous owner used RTV in some places. And there was a still a touch of water in the oil, but nothing scary. On the other hand, the o-ring on