Hi Mohammed, Yes, we have the original fittings on the fresh water pressure pump. Olivier said to always where possible keep everything original, what you think might not mean much can change

Thank you Barry. The pictures will definitely help. We also had to replace the rubber bladder (purchased in Lesvos Greece) and the pressure switch (purchased in Turkey), The replacement was not a

James, I believe David is saying that the handrail bolts go into a steel (iron) threaded plate that is embedded in the fiberglass deck. No bolts are involved. Amel used this technique in many ares,

Bill and Joel, Thanks for the reply. Yes, the iron itself seems dented. I cannot detect any other issue associated with this incident except my nightmarish recollection of the

Hi Mark. Based on closely examining hundreds of AMEL keels during the haul out for marine survey during the sales process, I have rarely seen a keel where the coatings were completely intact. In a

Mark, I think it is probably impossible for someone to assess your situation without an inspection and the expertise to evaluate the entire situation, but I will offer a non-expert comment. The best

I hit a rock and put a small-ish dent on the front of the iron keel. It seems to have broken through the epoxy and exposed the iron in a 6 inch by 2 inch (15 cm by 5 cm) section. My question is

Hi Mohammed, I hope that these photos of the pressure switch and indicator gauge help you. We have just had the rubber inside tank bladder and pressure switch replaced at AMEL Hyeres. They set the

Do make sure that the threaded section is long enough to reach through the hole in the Lofrans. 4 years ago Amel in Hyeres gave us two but they were too short. Ian and Judy, Pen Azen, SM 302,

I hope the photo comes through. It is exactly what Amel used. Fair Winds Eric Kimberlite Amel Super Maramu #376 Regards, David Barrett Technical Support/Customer Service

I hope the photo comes through. It is exactly what Amel used. Fair Winds Eric Kimberlite Amel Super Maramu #376

Bill, Thanks for all the help!!!! Everyone, I ordered one and will let you know if it fits, or not. With best regards, Mark Super Maramu 2000 Hull

You have a pipe “elbow” that for some strange reason was drilled and tapped to turn it into a pipe cross. As you discovered, this is not a good idea. You need a real standard pipe “cross”

Yes, it looks modified, but I cannot tell for sure because I have the AMFA 66B, which is different from what you have. Hopefully someone else has your model. Bill Rouse BeBe Amel 53 #387 Sent from

Bill; Yes I did. This was my first picture upload which I did under a new folder. I did post a link as well. Are you able to see it?

Mohammad, Did you upload: Fitting at water pressure tank Amel 54 Updated on 12:43 AM by mshirlooFitting at water pressure tank Amel 54

Mark and everyone else, Check this out on eBay. I think this is the same plastic momentary switch that is at Budget Marine. It is US $6.99 with free US

Bill; Here's a link to the photo I just uploaded. This is the existing "non-factory" fitting that is currently installed adn needs to be

Thanks Bill for the prompt response, as always. The main issue I currently have, is the brass fitting at the supply side of the water pressure tank. Some one has just taken a 90 degree brass fitting,

David, I agree with the preemptive approach. With the handrails I am unclear on how they are fastened. Are there nuts under the headliner or??? Best, James Alton SV Sueno, Maramu