Hi Eric, Mine is a much older boat, but I'm fairly certain the shaft size is the same on all. My shaft size is 35 mm, and I know this because we broke our coupling after a re-power due to poor

Hi Oliver, Thank you for the response we look forward to hearing from you. Enjoy your trip. Regards Steve On Tuesday, 3 January 2017, 22:14, "Oliver Buhlert obuhlert@...

Patrick, Thanks. I am thinking that I can make it mostly from PVC tubes. Amel price is over $300.00. Vladimir 202 258 1916

Vladimir, Too bad you could have borrowed mine when you were here a few days ago picking up the watermaker. I can bring it down with me this spring , when we service your bowthruster or send you the

Probably true. After confirming battery viability, I'll be looking for circuit leak. In any event i intend to install a small charger like BeBe has installed. Ben Driver La Bella Vita SM #347

Hi Duane. Be sure they are giving you a sprag bearing. $60 seems very cheap.. Mine cost NZ$300. Regards Danby SM 299 Ocean pearl

Hi bob. Yes I found the same problem so I used bolts threaded both ends. Worked happilly for the last 5 years. Cheers Danny SM 299 Ocean pearl

Danny, You were absolutely right. I took off the 24 volt pulley and it has a one-way bearing (clutch bearing) that is shot. It also has a "collar" inside the clutch bearing that is in contact with

Due to an illness with my girlfriend I will not be able to have Olivier come to St Maarten, I believe there is enough interest in the group to have him spend a few days on a number of boats. Please

Ben, I believe you have a bad battery or possibly a small current drain on the battery caused by a bad connection. . I have left Kimberlite sitting for months and have never had a problem with that

It is a six month old battery from Grenada. It drops to 10.4 volts In about 30 days. I plan to load test this weekend Ben Driver La Bella Vita SM #347

V, These are my thoughts and opinions: All of the bonding wires join near the C Drive at the top of the gray water tank. The zinc on the prop will be used for the entire bonding system because it is

Here is a photo, but can’t access to it. http://nikimat.com/bow_thruster_overhaul.html Sincerely, Alexandre --------------------------------------------

It is not as simple as it seems. You will find Bow Thruster Special Tool.jpg in the photo section and I have attached a personal copy for Vladimir. Bill BeBe St John

When I purchased my Amel-Super-Maramu I have had plastic cone on the prop. On all my previous boats it was zinks. I decided to replace plastic cone with zink. I still don't know why it was

Hi Bob, Do you happen to know the size (diameter) of the coupling shaft . I want to purchase one to use to make an alignment plate to change the motor mounts. However Vetus stocks 4 sizes. Fair

Can somebody send me a photo of Amel tool for removing Bowthruster in the water. I also need dimensions of the wooden piece. I need diameter and length. I want to make this tool. Vladimir Sonsev SM

Ben, how long does it take to flatten your starting battery? I have had occasion to visit and assess Amel Super Maramus that would be offered for sale that had been left unattended for three months

I have for selling the original AMELRubber rails for Super Maramu 2000 or Santorin. 2 x 16m. Quite NEW. AMEL sell them for 26.65 € / meter + Tax. That is € 852.8 + TAX. I will sellthem

One of the shortcomings of my boat as there is no shore power charger for starter battery. If boat sits starter battery invariable goes down. Has anyone rigged a small charger to address this?