Ben, Problem solved! I had no idea that was there. Thank you very much! Joe On Wed, Jul 13, 2016 at 10:39 PM, Ben Driver/YAHOO joedoakes66@... [amelyachtowners] <amelyachtowners@...> wrote:

You blew breaker on generator. On back side of control box is 30 amp breaker you need reset Ben Driver La Bella Vita SM #347

Hello, Tonight as I was charging my batteries using the Onan generator I was also running 3 AC units. Everything was running fine. I turned on my 160L watermaker and was letting it go through it's

If I was charging $40 a gallon for methanol anybody else's methanol would sure clog up my works!

I have built a fuel polisher from component parts. It comprises of a knock off Racor 900 filter unit, a 24v 1gpm fuel pump, an alge-x 500 fuel treatment unit ( used on eBay ) and a timer all mounted

These run on methyl alcohol, not hydrogen. Their current manuals insist on using EFOY fuel as they had problems with bad fuel from other sources clogging up the works. -Nathan Maramu #29

Hi Daniel, I have not an Efoy but I know and I sailed in boats where was installed. Bill is right is no cheap and infact I think could be an optional to add to solar panel sistem. EFOY is a very good

I have looked at them for a previous boat, and was completely put off by the cost. The “fuel cartridges” retail for about US$80 here in the USA, that’s for 11.1 kW-hrs of power. Running the

Hi Daniel, I thought about it... 5 seconds or so! Biggest problem is the fuel. Have you EVER seen a liquid hydrogen dispenser? Not yet a mature solution. Jean-Pierre Germain Eleuthera SM007

Not on my Amel. If I did, probably in the engine room or even one of the heads under the towel racks (they output waste water so you need a drain). But, the short version: Quiet! Doesn't need

Hello Has anybody installed an EFOY fuel cell on the boat? If yes, where is it installed and what are the experiences? Best - Daniel HEUREKA Santorin No 64 (1992) Kuşadası, Turkey

Hello Mohammad. Answers below: The bimini is the original one supplied with the boat. The only modification was to add two S/S steel struts at the back of the bimini frame from the glass fibre

HiTony; I did receive it.Thank you. So you had to make a new bimini stainless structure or just added oneto the top? Can you please sendme a link to the solar panel and controller that you used.

Hi Mohammed, Is it possible for you to upload the photos to the group that you received from Tony of the solar panels on the arch? We are planning to install solar panels at the end of this month on

Mohammad - I've resent the picture to your email address mshirloo at transpacific dot us. Let me know if you receive it. Tony Robinson. From: "'Mohammad Shirloo' mshirloo@...

Hi Bill & all, I bought the sensors from the Pochon office in La Rocelle in May 2015. Maud Touillet at Amel told me to contact them. The person to contact at Pochon is Stephane Geniteau, the

Hi Tony; You mentioned that you had attached photos but I did not see an attachment to the email. I believe the pictures have to be uploaded to yahoo and cannot be attached to group postings.

panels are 200W each 1580H x 808W x 40D...and yes they are Chinese. AA Solar - Importers and Distributors of Solar Panels and Alternative Power Systems AA Solar - Importers and

Our panel installation is exactly the same as Bill Rouse's on Bebe. There are pictutres here I'm sure, but I'll post one anyway. Cheers Alan Elyse SM437

Mohammad. Attached is a photo of my installation. Note the charging wire down the side of the doghouse which, as I said, I have fed directly into the battery compartment via the vent tube behind the