Yes. There is a dedicated 20amp breaker for the SSB in the hanging locker by the nav station. This should go to the terminal label BLU. The SSB should be the only item on this circuit. From the

Thanks Barry for helping Peter. The labels on my knobs are completely worn off. I am planning a new microwave this year. Someone with a SM recommended a Panasonic unit. It looks great and fits fine in

Thank you then I'm on the right track in my installation Paul

Hi Paul, BLU is “froggie” for HF… it is not a general use CB Cheers, Jean-Pierre Germain, SY Eleuthera, Amel Super Maramu 007

Thank you, find the BLU, blank terminal, I also have a circuit beaker at the side of the chart table market BLU as well. Is BLU a spare breaker/terminal for general use? Paul

Hi Peter, Not on the boat at this moment. 2 top twist knobs: top is for microwave oven program, underneath twist knob is for time. 2 push buttons at bottom: left when pressed in stops turntable

Jamie, It has twist knobs. I just really need to know which way to turn what knob to get Grill and which for microwave. Peter Peter Forbes 0044 7836 209730 ppsforbes@... Carango Sailing Ketch Amel 54

Paul, Behind the chart table there is a green/yellow wire marked BLU. Without the SSB this cable is connected to the SSB grounding plate on the rudder and also to the ships boding system (zincs).

Thank you! Do you or anyone else know where the thick (the thickest of man yellow and green ca 8 mm in diameter) yellow and green ground cable ends? it goes from a ground point behind the chart table

Not sure, but I think I have the same unit. Does it have twist knobs versus electronic buttons? Is there something you need from the manual? I might be able to scan. It is not a full-size

Jamie, Thank you - it is called FAGOR MW-MW3 176G. Does that help. is there an electronic manual I can download from somewhere? Peter Peter Forbes 0044 7836 209730 ppsforbes@... Carango Sailing

I do, but it depends on which microwave you have. Jamie Wendell s/v Phantom Amel 54

Does anyone have a manual for operating the microwave on the Amel 54? Peter Peter Forbes 0044 7836 209730 ppsforbes@... Carango Sailing Ketch Amel 54 #035 Travelling West in the Caribbean

That's what I thought, thanks Richard. Kent

Kent the run on high heaters are the combo AC/heating units with Ele heat. Those fans MUST run on hi to keep the elements from melting/blowing their internal fuse. Fair Winds Smooth Sailing To

I remember reading on this forum that the electric heaters should only be run on the High fan setting. Is that correct? If so, your plan to run all 3 on low may not be a good idea. Kent SM243 Kristy

Thank you all for your suggestions! I have contacted Fakir and they are actually working with a company they distribute to in Kansas to see if they can import 2 new units for me. In the mean time does

Hi Paul, Since they are 24v relays it is unlikely they are actually after the 24-->12v converter, as that would put them in the 12v circuit and they would not function. Probably well enough left

Hi Paul. I connected with grub screws and wire all of the boom, bolts, block and mast. Didn't seem to help. I considered grounding it, ie connecting it to the boats grounding circuit system that is