I took the liberty to change the subject line.... An other possibility is in Aghios Nikolaos on northeast coast of Crete. It is a night sail from Rohdes. A very nice marina where you can choose to

Dear Gerhard, I reached Rhodes after a long summer cruise from Porto Karras (Halkidiki) to Kastellorizo, my intention was to leave Sisila (Amel Santorin #84) in Leros, but I was not able to reach the

The pump is still available through Amel or directly at Reya in Toulon (France) I hope this email is readable, otherwise I this is the link:

Installed a Vetus unit… http://www.vetus-shop.com/waste-waterbilge-pump-24-volt-hose-conn-38mm-p-2387.html Buy extra duck bill valves and 2 kits of spares. Clean the sewer to perfection before

I purchase my rebuild kit from Amel. Just rebuild the Reya ZZ Marina Bilge pump, works perfectly! Sincerely, Alexandre SM2K $289 NIKIMAT Blue Haven Marina, Turks &

Has anyone found a replacement source or suitable substitute for the original equipment bilge pump? Jeff LAST TANGO

Alan, I assumed that's what most would do and I assume it's easy enough to accomplish. One of the anode suppliers noted there was a stainless steel nut embedded in one of the halves. That would be

Hi All, Although not (yet) an owner, I had a brief side discussion also with Bill from BeBe last year about the structure and so on of the most-valuable information on this group. I elective that it

Alain, Thanks for checking that out. True, the .PDF is not loaded yet. Had to catch a plane and ran out of time. I'll haul the laptop to the marina today and see if I can't finish that up. A

Subject: Leroy Somer outhaul motor. Has any one replaced the Leroy Somer outhaul electric motor and if so do you have a source for them. Would appreciate help here. Regards Danny SM 299 Ocean

They must have changed it for me at some point then. In Imperial Units terms, standard bolt, standard thread. Though it wouldn't surprise me if the zincs were "close enough" and only the

I buy the standard R5 anode, take out the small bolt that comes with it and countersink and drill the hole out to take the Amel bolt. I carry a spare set already modified ready to

Hi Mark, no I don't but I would start with a hacksaw blade held in the hand and gently cut around it. Regards Danny SM 299 Ocean Pearl

I bought the standard R5 "trim tab" anode and the bolt is pretty small compared to the present bolt - about 1/2" according to the diver. Can someone give me a source for a suitable

Vladimir, with your 75 H.P. engine, if you have a Max-Prop, that speed and RPM are about right, well within the range. If you have an Auto-Prop, the RPM are about 600 slower and that speed is a bit

Help Sorry to butt in on the wrong topic, but I can't log in to the Yahoo address any more. I have tried all the passwords I ever possessed. The only way Yahoo offers help is to send me a message on

Joel, Max RPM is 2900 at 8.2 kn speed. Is this OK?

The German supeyer SVB have this https://www.svb.de/de/aqua-signal-led-dreifarben-ankerlaterne-serie-34-schwarzes-gehaeuse.html#more_info Elja Sy Balu Super Maramu 222

Hi Gary, I tested the ability to use the "Imported from yahoo Group/Imported messages" board. I can read and search as a charm in the html format. When I try to access the PDF file I get an "Error

Danny, Thanks! This is very reassuring. Perhaps I’m over thinking this a little bit. One more question: do you remember what tool you used to separate the copper tube from the fiberglass