Hi Vladan, sorry I dont. Havent been there yet. Kind Regards Danny SM 299 Ocean Pearl

Hi Bill, Number 5 is not V seal. V seal was supplied only one piece and I used it. Attached more photos. Best Regards, Vladan - SV Pame A54 # 157 Get Outlook for iOS

Hi group, I need to replace on of two sensors that control up and down position of pasarella. I managed to unscrew it from the bracket. Does anyone know where sensor cable ends? As far as I can see

Vladan, The photo is too blurry for me to read. Is it possible that #5 is the V-Seal?

Hello Lior. I used to own Amel 54 # 14, 2006 model. Very shortly after I sailed the boat here to Florida, the 9000 BTU Climma air conditioner in the aft cabin had a compressor failure. I removed the

Hello Lior, I replaced 2 air conditioning units on my 54, the saloon one (12,000 BTU) and the rear cabin one (9,000 BTU). The new 9000 model (Climma) for the rear cabin is identical to the old one in

Have a look in the webasto it is same size and it seems to me more modern design. I have replaced the cockpit Aircondition with a webasto 12000 Στάλθηκε από το iPhone of Dimitris

Dear all, Thank you very much for the feedback. The Pump worked as I started the AC but it became very hot and the compressor made a very strange noise. I am quite sure that this unit is in its

Hi Danny, I think you are referring to anti dust seal. That one I used and installed. If I was not precise in my post, In Amel kit was supplied two number 5 seals and I used only one of

Hi Vladan. Having just serviced my main sail furler I suspect from your photo this mounts externally on the output shaft sitting down on the top of the housing. One caviat on that opinion is I was

Hi Stefan, I bought set of seals for main sail manual furler in March this year from Amel. After replacing them all on main sail furler I remained with one seal that I don’t know what is for. In

Maybe you could let us know what model you are looking for? Michael Nebo sm251, Some times you will have to upgrade systems , rigging, electronics, apart from the costs it's all time consuming. How

 Hey JB, I have the same "in front of the mizzen" arrangement as you. The issue with that arrangement is that the width of the panels is constrained by the mizzen and the boom and/or topping lift.

Hi Laurens, Please be aware I’m working with Sofomarin as well. Some moths ago I helped designing a new secondary manifold together with Bill Rouse and others. This has been in place since on our

Hi Paul, You have it all with Joel and Bill. Olivier to survey. Even more importantly, what little these guys don't know, they have immediate resource available to fill the gaps. Coupled

Arno, I agree there is not a documented middle position.

As long as you apply the sealant to the sides, I cannot see how it will have an adverse effect. Do not lose the cap, they cannot be purchased separately.

There is one relay for each Climma Compact unit CW Bill

I forwarded this to Sabine Stein CW Bill Rouse

I can confirm the three way valve starts leaking after xxx time. I had to replace mine last year. By the way I don’t think there is a documented middle postion for the valve by the way. I only use