Jose, I am curious to know if you have observed exactly where the water is coming in? I am wondering if maybe there could be a hole, crack or something else that is causing the leakage? James

Eric you can't enter your e-mail with the "at" sign because Yahoo will take it out. My e-mail is josegvenegas(at).icloud.com Send me a note and we will get connected via mobil phone Jose

Hello Jean Pierre, I saw it on the pictures you put on FB, this is on my list of things to get, but I can’t find one… Where did you get

No, no, I had the same problem. After 8 months the impeller would loose all its blade (only putting 80 hours). I had the water pump rebuilt and the person said: 'look how dirty it is'... so we

I tried one a few years back. It lasted less than one minute and it was not dry. Miles Ladybug, sm216 Newport, RI

Ann Sofie, Yes not only I pass the pin, but I have added an extra seal to increase the sealing force without results. Of course no pin results in a lot of water running into the boat very

OK....that's why the impeller still looks OK.. I think most people get between 150 to 200 hours from an impeller. Cheers Alan Elyse SM437

Hi Gang, Some time ago, we made the following mods to the MDKAL B. We added a one way spring ball valve to the water intake side. On the outlet to the heat exchanger, we placed a diverter filter to

I run very little time my Onan. On average I would say 8 hours/month. So about 80 hours in 10 months. Sincerely, Alexandre --------------------------------------------

Hi Alexandre, I replaced the ONAN pump with a new Sherwood one piece cast (beautifully machined) pump, and I still have the same problem.....it seems this is a well known issue with ONAN, there was a

Hello Alan, I used to have the same problem. After 8 months the impeller would lost is blade. So Dec 2014 I cleaned the water pump, see pictures on the link below. And 10 months later, preparing for

I changed the whole pump for a Sherwood one-piece housing and I have used Globe Run Dry impellers on the Onan with very little difference in longevity cf the standard impeller...about 170 to 195 hours

Correct Kent! Bill Rouse BeBe Amel 53 #387 Sent from my tablet +1832-380-4970 USA Voice Mail On Jun 8, 2016 8:01 AM, "Kent Robertson karkauai@... [amelyachtowners]" <amelyachtowners@...> wrote:

Hi all, I just have had the mizzen shaft become uncoupled from the roller reefing. The shaft can be pulled out about five inches, and then it will come no further. How is this shaft normally

Well Craig, i'll do that. Could you also give me directions on my request of 3 june (no.27337) relating to the new charger installation and earth connection? I'm sorry i could not meet u in Greece

Thanks for the info Bill, How long did they last before failing? Sincerely, Alexandre SM2K #289 NIKIMAT Club Nautico de San Juan, Puerto Rico --------------------------------------------

I normally stay well clear of products that are hyped as better and different than OEM equipment parts. Globe Run Dry Impellers is one of those products. But, I tried the famous Globe Impeller in

Thanks Bill. This make sense now. With best regards, Mark Super Maramu 2000 Hull #275 www.creampuff.us Currently cruising: Tampa Bay for hurricane season

Mark, This seems to have confused a lot of people commenting here. The changed seal is NOT the seal on the vertical shaft that keeps water out of the boat. It IS the seal that keeps water out of the

I am a little confused about the mentioned tool to put on the new lip seals. Isn’t this seal adhered to the inside of the vessel before pulling up the shaft of the bow thruster into the motor? How