Thank you Bill, I hoped you would not press the issue as I have high regard for your technical knowledge and advice regarding Amel boats. In fact, based on your good experience at Emek, I chose to

All interested in Amel maintenance Turkey, I know the Amel Representative for Sales and Service in Turkey, Emek Marine in Gocek. I know Riza, the third generation manager of Emek. I have used Emek

Hi Craig, At The end I changed The forestay: I cut the old cable because was impossible remove it. The reason was that inside The furler there was a mixture of salt, grease, dirt, rubbish and so

regarding antifouling I can highly recommend Mohammed Mrad in Monastir - got mne coppercoated there in April 16 - they did a great job! I brought all the necessary materials frm Malta as coppercoat is

I am getting complete rerig in Gibraltar along with some other work (once I have moved Caramba SM 2000 from Tunisia in June). May be wrong end of med but I will let you know how I fair. I am still

Hello The works I have done: - replacing standing rigging - replacing all internal wallpapers - Revision of Perkins Prima M50 - Paintworks/New Antifouling Fortunately my experiences were not so bad as

How many different gaskets do they have? If a small number would it be easier to buy one of each?

I only replaced the housing, which was cracked, and not the transducer, so I cannot comment on an experience with the cable. Mark Pitt Sabbatical III, ASM #419, Carloforte, Sardinia

I want to replace the magnetic gasket of the Frigoboat fridge on BeBe #387. I think I will have to remove the fridge to locate the model number, and Coastal Climate and Frigoboat/Italy insist they

Nice note / post thanks Fair Winds Smooth Sailing To All Capt Richard RP Yacht Brokerage Newport RI We list sell and service fine yachts including Amel's Cell 603 767 5330

Yep...we don't have one but my son and my daughter (both merchant marine bridge officers) recite "RED OVER GREEN IT'S A SAILING MACHINE" and tell me I need one. My understanding is that the red over

While in Martinique, I saw a single LED bulb that had 2 wires. The bulb had 3 switchable modes which were an Anchor light, a TriColor, and a Strobe which broadcast SOS. It switched from one mode to

Thanks Herbert, this is much helpful.

We had a lot of work done on our santorin in Kusadasi, Turkey. As Daniel already saíd Basar and Zafar (sails and canvas) are very honest and reliable, excellent partners for boat-work and nice and

When the plastic part that transforms the rotary action of the motor into the push-pull action of the piston started to slip on our old AMFA bilge pump, Amel sent us a replacement to Fort Lauderdale

Bill, I have gotten the attention of ships with my strobe over a mile away. Last summer I was sailing and saw that a vessels closest point of approach was 13 feet. I continuously called them before

Craig, We all use the tools that make sense to us. My thinking has always been if playing my searchlight across the offending vessel’s bridge doesn’t get their attention, the strobe light is

Hi Eric, No, it has its own mounting bracket, so likely not plug and play with Aqua Signal, although it is very simple. Craig ---In amelyachtowners@..., <kimberlite@...> wrote : Hi Craig, Does that

Hi Vladimir, The rotary switch is quite small and I put it next to the switch panel with the Anchor and Tricolor switches. I'm quite sure you could use two toggles, where both on would give the

Hi Bill, Interesting point about strobe use. After a too close call with an incorrectly lit freighter off Tunisia (he was showing a 180 degree red light forward, obliterating his green and red running