Dereck, I have found that if you make the temporary bowline longer the two bowlines do not have to travel through the notch in the mast at the same time. Fair Winds Eric Kimberlite Amel Super

Good afternoon Mike, I purchased my Super Maramu 2000 in Martinique. I used Martial Barriel and was very happy with his services. Tel: 0590 28 14 41 - Mob : 069055 42

Hello Everyone, Is there anyone here who has purchased an Amel in Martinique and could recommend a good surveyor on the island? Thanks, Mike

Yes, I am a "green striper" as the result of following Gary's instructions and UV. I have had several people ask me where to buy the green. I have told them all the full story. We have only done

Hi Bill: You are great. I am off the boat now for 6 months and I looked to see if I had any stock photos that I could post. At first pass I can't see any. Thanks in advance for posting

Hi Stephanie: My SM is a 2001 and has lived most of its life in the Caribbean. I have completed the deck strip painting process twice. The comments about "peeling" off perhaps pertained to my

Alex, In the US there is an adjustable plumbers spanner tool that works perfectly. I will post a photo tomorrow on the Amel Group. Bill Rouse BeBe Amel 53 #387 Sent from my tablet +39 333 121 8115

Thanks so much Bill !!! --------------------------------------------

Alex, I will post a photo tomorrow. Bill Rouse BeBe Amel 53 #387 Sent from my tablet +39 333 121 8115 Italy Mobile +1832-380-4970 USA Voice Mail On Jun 8, 2015 4:11 PM, "Alexandre Uster von Baar

Hi Gary and everyone, I am late to the discussion because we have been on the move in the Med. Gary Silver is absolutely the best person to discuss and explain the Amel Bow Thruster. Most of you

Good morning Trevor, Thanks for your reply. Saving your message. No problem at the time with the rudder, but will had to my list to have a spanner made. Also good info for the pipe for the drive

Dear Gary, as always thanks so much for your explanations. Is there any way you (or someone) could take a pictures of: the “Adjustment screw”? Referring to the phrase: "The pin alignment is

Derick I think the thin line protruding from the slot at the top of the mast will be attached to the traveller that runs up and down the furling foil – the substantial halyard then attaches to the

Hi everyone: I watched these discussion but had limited internet access while sailing so haven't replied prior to this. Regarding adding a third foam seam on the exterior position of the bow

Hi Alan I should have scrolled up to your post before I repeated your advice. Cheers Danny From: "divanz620@... [amelyachtowners]" To: amelyachtowners@... Sent: Monday, 8 June 2015 6:26

Hi Derrick, to attach an extension to the short halyard all you have to do is form a loop in the tail using a bowline knot. Pass your extension through this loop and form a loop again with a bowline

Hi Derick, Bad luck with the halyard ! If you use a similar diameter line and tie it to the halyard with a bowline it will go through the slot in the mast with a bit of pushing, and the line doesn't

Today on a beautiful reach from St. Thomas to Culebra the mainsail halyard let go. Over the course of a few minutes the sail slowly slid down the track in the roller reefing, and we were forced to

Dear Alexandre, Unfortunately the spanner is under the bunk on the boat in Mexico and I am in Ireland. It couldn't be more simple. I took an A4 piece of paper, measured the

Hi Bill, Happy Birthday, have a great day. Mike & Peta Solitude SM 2K 461