Great work, Bill. Much appreciated. I am most impressed with the quality of construction of the Incidences Sails and I‘ve bought a lot of sails over the years from all the major makers like

Looks like this? https://www.motaindustrialcooling.com/en/g-range/43-g058-235-1cc32-oil-cooler-version-cc32.html ~~~⛵️~~~Matt

Thanks very much, Mark, for the post! My oil cooler on the 55 looks like the photo Bill posted. When I get back to the boat in September, I can take a look to see what make and model it is and

Yep, I could not find C9 made by Mota CW Bill Rouse

Two depressions on the C9 for hose clamp mounting, vs one for the one you show…. ~~~⛵️~~~Matt

Looks a bit different than that. Says “C9” on it. ~~~⛵️~~~Matt

Matt, Thanks for that. It is likely this cooler: Tubestack diametre (Ømm) 58 Connection on cold side Ø52mm hose Connection on hot side G3/8" (BSP) thread Tubes material Copper-Nickel

A-50: It’s got the word “mota” stamped on it. ~~~⛵️~~~Matt

For A55 owners and possibly A50 owners (an A50 owner please verify) There is a different oil cooler that Amel used in the A55 (possibly all hull numbers). I am not sure of the brand, but the same

Scott, same Bowman cooler on Yanmar SMs and 54 D3s. Bowman DC_Oil_Coolers_-_Iss_J.pdf It is very important to inspect the end of the cooler nearest the sea chest. This is where debris will accumulate

Mark, congrats on a great post as the transmission oil cooler is particularly important learning for all new or existing SM and/or 54 owners. We had a similar experience on SM Island Pearl II (2001

Thanks Bill. Greatly appreciated. Don’t need sails yet, but it’s a great feeling to have this solution.

As Michelle and I are preparing to do our electrical system upgrade (arch, rigid panels, inverter/charger, LiFePO4 batteries), I came across several new CIGS flexible panels. The white papers on

Thanks Scott. The problem with fear is that it has an irrational component and so defies logic. Strange times. Delighted you got down to French Polynesia. Paul -- Paul Harries Prospective Amel

Hi James, William Walsh Marine Surveyor Tel. +306941 602 677 Email: wwalsh@... www.walshmarine.gr He is based in Pireus but he will travel all over Greece. We have seen him do a survey on an

Thanks Bill, for all your efforts. Respectfully; Mohammad and Aty B&B Kokomo Amel 54 #099

Good morning Eric, I might have some plastic slider left. Sincerely, Alexandre

Hi Mark; Thank you for sharing your experience. We removed and had all of the heat exchangers professionally cleaned in 2018. However, it is not possible to identify wear. Therefore I’d like to

Hi to all, Im planning to purchase a new Q Sails yhdranet genoa for Eutikia. Any experience about ? Alternatives ? Many thanks Giovanni Testa Eutikia SM2k 428 Preveza GR

Bill, thanks, attached is my drawing. All the best Dieter