We have 110hp Ynamar and I think you have a bit more power in reserve when the going gets tough. Probably not much difference in flat water. Cheers Alan Elyse SM437

Hallo Hanspeter, I have only own my SM2K since 2012, so my experience is limited. I have the Volvo TMD 22 P (same as Perkins M80T) which is rated for 78HP at 4500 RPM Until 2 months ago, I was only

Question to all SM owners Whats the different between 80 hp and 110 hp Max Speed for SM is ca 8.5 kn Independent how much power, the power on the Prop is Important I have this speed with clean

Olivier You are the man Hanspeter SM 16 Tamango 2 Gözek Türkei Von meinem iPhone gesendet Am 25.06.2015 um 21:32 schrieb "Beaute Olivier atlanticyachtsurvey@... [amelyachtowners]"

Hi again Wolfgang, the FURUNO pilot you have, with L&S hydraulic pump and strut is a very reliable system. If you want better, you should have a full second one installed. Although I never tested it,

Hi Wolfgang, you must have used your bow-thruster a lot! It usually stops after 3 minutes of use (like 18 times 10 seconds). Making a way to ventilate the bow-thruster will not change much about motor

Thanks Derrick...will do. Steve Aloha SM72

Steve, If you have followed Kent's saga, you are probably already aware that new engines installed on Amel boats need to be isolated from DC ground. That means you will want to transfer to your new

Can't wait to see the before and after. I really understand the delay issue. Steve

Yep....Yanmar 80 turbo. We are trying to sort out the 2 alternator option, and then get the engine to the yard in St Augustine. With a little luck, we will get North by late July or early August. You

Wise choice Steve.. JPG

Hi Steve and Liz, We are in Goček Turkey, tolerating the delays... We are preparing a before and after document for interested viewers. I will send you the link soon. Cheers

I'll be late getting there, too, Steve. Going to get the electrical problems solved before I go North again. Still hope to be Cape Cod area by midJuly. I think you're making the right decision about

Thanks Kent. We have decided to go with the 80hp, as I just don't want to risk CDrive issues. I hope you have your electrical gremlins sorted soon, and are back on the water. We still hope to see you

Thanks for the info Chris. It looks like 80 hp is the way to go on our older boats due to the Cdrive issues. Regards, Steve and Liz Aloha SM72

Thanks Jean-Pierrre. I'd love to have a simple normally aspirated engine, but we don't seem to have many non turbo options. John Deere makes an 80hp, but I need to check on fitment issues. How is you

Thanks for the info. We have decided to go with the Yanmar 80hp, and not risk any Cdrive issues. I feel that 80hp is adequate, and I like the concept of less fuel consumption as well. Hopefully, we

Great info! Thanks Bill! Sincerely, Alexandre SM2K #289 NIKIMAT Grand Bahama. --------------------------------------------

I just wrote out the step-by-step procedures of using the Dessalator screw-on hose connectors with new HP hose on a 160 Liter water maker installed on a Super Maramu. It is in the FILES section under

Hello, This email message is a notification to let you know that a file has been uploaded to the Files area of the amelyachtowners group. File : /Miscellaneous/Dessalator Install HP