I do not remember who had a problem with the fresh water pump cycling, but I had suggested the one-way valve as being one of the causes. I had a piece of trash lodge itself in the one-way valve

Alexandre Yes that looks the same – many thanks Andrew Ronpische SM2k 472 Canet en Roussillion, France

Good morning Andrew, On NIKIMAT (SM2K #289) the Gas light bulb is a: miniature light bulb 757 Since my vessel is older than yours, double check

Hello, This email message is a notification to let you know that a file has been uploaded to the Files area of the amelyachtowners group. File : /Miscellaneous/BOW THRUSTER RIGGING HOW TO

My previous owner could only find 12V replacements and they burnt out very quickly... I found the same lamp in 24V from RS components, and 2 yrs on it is still working....and I have a

I replaced mine with an LED several years ago, Andrew, but it didn't last 24 hours. I'll try again when the current incandescent quits. Kent SM243 Kristy

Several comments have posited that the bulbs are burning out due to high voltage, which may well be the case. On our SN there is a Linear Fixed Voltage Regulator, which I believe was originally

Our GAS indicator panel light just stopped working – I am quite keen to change it for an LED indicator instead has anyone sourced a good replacement for this or if not know the diameter of the hole

Dereck, I have found that if you make the temporary bowline longer the two bowlines do not have to travel through the notch in the mast at the same time. Fair Winds Eric Kimberlite Amel Super

Good afternoon Mike, I purchased my Super Maramu 2000 in Martinique. I used Martial Barriel and was very happy with his services. Tel: 0590 28 14 41 - Mob : 069055 42

Hello Everyone, Is there anyone here who has purchased an Amel in Martinique and could recommend a good surveyor on the island? Thanks, Mike

Yes, I am a "green striper" as the result of following Gary's instructions and UV. I have had several people ask me where to buy the green. I have told them all the full story. We have only done

Hi Bill: You are great. I am off the boat now for 6 months and I looked to see if I had any stock photos that I could post. At first pass I can't see any. Thanks in advance for posting

Hi Stephanie: My SM is a 2001 and has lived most of its life in the Caribbean. I have completed the deck strip painting process twice. The comments about "peeling" off perhaps pertained to my

Alex, In the US there is an adjustable plumbers spanner tool that works perfectly. I will post a photo tomorrow on the Amel Group. Bill Rouse BeBe Amel 53 #387 Sent from my tablet +39 333 121 8115

Thanks so much Bill !!! --------------------------------------------

Alex, I will post a photo tomorrow. Bill Rouse BeBe Amel 53 #387 Sent from my tablet +39 333 121 8115 Italy Mobile +1832-380-4970 USA Voice Mail On Jun 8, 2015 4:11 PM, "Alexandre Uster von Baar

Hi Gary and everyone, I am late to the discussion because we have been on the move in the Med. Gary Silver is absolutely the best person to discuss and explain the Amel Bow Thruster. Most of you

Good morning Trevor, Thanks for your reply. Saving your message. No problem at the time with the rudder, but will had to my list to have a spanner made. Also good info for the pipe for the drive

Dear Gary, as always thanks so much for your explanations. Is there any way you (or someone) could take a pictures of: the “Adjustment screw”? Referring to the phrase: "The pin alignment is