Hi, Does anyone know where to get 30 mm metric hose that goes from the oil cooler to the sea chest for the Yanmar engine in the USA? Fair Winds Eric Amel Super Maramu #376 Kimberlite .

If they are the original, I'd expect 8mm all around (for the mainmast) and 5mm for the springstay. I think most older Maramu's have been re-rigged by now so it would be interesting to see how yours is

An Update: Danny, I can get all the way up over 3000 RPM in neutral. Joel, thank you for the data points below. I have contacted Geoff Prior of AB Marine who is helping me figure out if the prop is

Thanks Eric, Cummins Atlantic now has them too. Kent [Non-text portions of this message have been removed]

Hi Dave, we have the original Isomat Rig and rigging. All stays and shrouds are 1 x 19 stainless steel wire. I have a Rig drawing on the boat. Trust this is helpful. fair winds Andy Maramu #75

Try these: This is where I get my parts: Cummins Metropower 890 Zerega Avenue Bronx, NY 10473-1122 <http://g.co/maps/fxr9x> Phone Numbers Local: 718-892-2400

Dave, My Maramu was rerigged a couple of years ago. Somewhere I have the riggers list of wire sizes but I think it is onboard. I will try to find it. John #91 Maramu Popeye

Dave, That's good because so far I can't find it. If we were on the boat.... Anyway, I do have the dimensions of the rigging currently on the boat. It's obviously been re-rigged at some point,

Dave, One of the other list members was kind enough to email me a diagram that I suspect may be the same as you have. I'd like to see yours, in case there's additional info, but I don't want to see

Trevor, If you need any assistance with importation of parts, let me know. We send a lot of sails to Mexico and we have an excellent import agent that charges far less than the ones cruisers usually

Kent & the Group, I've had success getting Onan parts for SM384 from: Cummins Northwest 811 SW Grady Way Renton, WA 98055 USA +1 425-235-3400 fax +1

Sent: Thursday, June 20, 2013 5:27 PM To: amelyachtowners@... Cc: Donato Valente Subject: Wearing out ring Hello Donato, It was great meeting with your son and Pietro Frisani last week and

Thanks Dave I have. They can't get an angle on it and have referred me directly to Onan who I am waiting ti hear back from. T.

I ordered directly from the onan agent in Barcelona, via a local shipyard Peter Killen

I've been looking for a replacement sensor for the exhaust hose on my Onan for several months. My supplier says they are redesigning them and doesn't know when the new ones will be available.  Does

Hi everyone, I'm not on my boat and need to know the typenumber of the Jabsco seawater pump of my Paguro/Lombardini generator. This number is located on the cover of the impeller. Any help would be

Trevor, My Onan proceeded to conk out and I discovered the water sensor on the cooling pipe was faulty. We bypassed it until we could get a replace mt and all was well. Lots of cooling water coming

Trevor, Have you spoken with anyone from Total Yacht Service there in Mazatlan?

Oops, sorry, the pics are in the Kristy SM243 folder.

I've added a couple of pics of the bow seat I made out of Starbord. It is off-white and should match the Amel hull color well. I made a pattern by putting a piece of cardboard on the bow pulpit and