Hi Nick, great! good luck! THX for your feedback if you made the bargain. Where are you mooring in Patmos? in the southern bight Grikous, or in the northern bights? Main port Skala is currently under

Hi Ulrich 370 euros inc vat is more like it. Brand new OEM part. I will continue looking but that is probably the best bet. Thanks Nick S/Y Amelia AML 54-019 Patmos Waiting for the Meltemi to ease

hello Nick and Bill and all other Amelians, are interested in this parts…. genuine VP part number 38073053 is correct and confirmed. OEM part costs in Germany incl. VAT is 370,00 Euros. > Have a

Nick, Also eBay.co.uk https://www.ebay.co.uk/itm/332725465532

Great...I was afraid that I was wrong. I will email HDI about 3807305. You should also.

Eric, I like this one: Gianneschi 01CB22G302 95MM Impeller - 1841 GPH 1” In & Out 230VAC 50/60htz The original A.M.F.A MARINA pump has been duplicated by TF Pumps/Gianneschi Gianneschi Pumps

Hi Bill, the Volvo Penta part number is 3807305 which is the unit labelled 6 below Best Nick S/Y Amelia AML54-019 Greece

Eric About bilge pump Amel dont have anymore. you can find a new one at: -- TF MARINE SRL Lucca – Italy Tel & Fax: +39 0584 338238 website: www.tfmarine.it email: info@... Last 1 1/2 months to

Our Clapeda AC pump finally bit the dust. Some time ago it was suggested that the March AC-5C-MD 230 volt was a good substitute. I do have that one on board. However, it has open windings, it has a

On Sat, Jul 10, 2021 at 07:51 AM, Gregory Shea wrote: Hello GregFrom memory, I have not modified the original installation. Adapters were sufficient. I just had to force a little to connect to the

hi, my boat was one winter on the hard in Brindisi, naval balsamo boat yard. it is a family business. they offer all kind of work and for my opinion, they where very professional. best, Lior A54 #18

hello, Can you give more details of the names othe yards you were satisfied of ? Thank you. Denis Ex Meltem # 32

Nick, HDI Marine Ltd www.hdimarine.net manufacturers exhaust elbows by casting in one piece using the stainless steel investment cast process. It should be a buy one-time item and is usually

I had work done at a duty free (VAT) yard in Pula. Commodore and they did a nice job of everything they handled especially the new paint job. If you are non EU flagged the savings can be considerable.

Jose Alegria Amel55 #03-MERIT +351918663037 Josealegr@... Início da mensagem reencaminhada:

Nick, My Volvo TMD22a is actually a Perkins engine ,and I have found prices for the Perkins M80 (my engine ) is less than half that it would be if I ordered the same Volvo part. If your Volvo is a

Hi Bill , Yes I am in communication with Maude tks regards steve

Since replacing the turbo heat shield I can now visually inspect the exhaust elbow. To that end I am no longer in blissful ignorance. As shown in the photo the weld is corroding. Hot exhaust gas meets

One method of eliminating potential sources of the problem, without any alterations or jumper installation, is to simply listen for the main solenoid activating when using the Joy Stick. If you can

Hello, This goes back to a 2019 post, see below and I’m hoping that sharki.cigale is still on the forum. I bought the faucet referenced below at Leroy Merlin and have been anxiously waiting an