|
Genuafurler
I have bad expierence with my genua- furler.Every season break the belt
inside the furler
2 times.What could be the reason for this?
Thank you for your advice!
Christoph Höke SAM III
I have bad expierence with my genua- furler.Every season break the belt
inside the furler
2 times.What could be the reason for this?
Thank you for your advice!
Christoph Höke SAM III
|
By
Christoph <christophhoeke@...>
·
#11703
·
|
|
Re: [Amel] Rudder cables
Dave,
I have a reply from Ultraflex regarding lubrication of the steering cable which confirms what I thought. By the way the same applies to the engine control cables, lubrication is not
Dave,
I have a reply from Ultraflex regarding lubrication of the steering cable which confirms what I thought. By the way the same applies to the engine control cables, lubrication is not
|
By
GrahamJohnston42 <grahamjohnston42@yahoo.com>
·
#11702
·
|
|
Re: Luff tape size for main and mizzen?
We've built sails for Nirvana furler equipped Amel's and used a #10H tape. I carry a full range of luff tape samples with me so I can verify the size. I've seen some Amel sails built with smaller
We've built sails for Nirvana furler equipped Amel's and used a #10H tape. I carry a full range of luff tape samples with me so I can verify the size. I've seen some Amel sails built with smaller
|
By
Dave_Benjamin
·
#11701
·
|
|
Re: Amel 54 Polar
Could you use 53 ft. charts?
Tom Christensen
Could you use 53 ft. charts?
Tom Christensen
|
By
free2runandsail
·
#11700
·
|
|
Re: [Amel] Amel 54 Polar
There is no comparison between SM and Amel 54 the 54 is much faster and sail much better to windward with less wind. I owned an SM2000 before and I can compare the performance although I do not have
There is no comparison between SM and Amel 54 the 54 is much faster and sail much better to windward with less wind. I owned an SM2000 before and I can compare the performance although I do not have
|
By
Dimitris Krassopoulos <dkra@...>
·
#11699
·
|
|
Re: [Amel] Amel 54 Polar
If y check out the old messages there is a bit of info there.
Barb
Sueno Azul
Polar Diagram for Super Maramu < Prev Next >
Posted By: * closereach
* closereach
* Offline
* Send Email
If y check out the old messages there is a bit of info there.
Barb
Sueno Azul
Polar Diagram for Super Maramu < Prev Next >
Posted By: * closereach
* closereach
* Offline
* Send Email
|
By
Barbara Nairne
·
#11698
·
|
|
Re: [Amel] Luff tape size for main and mizzen?
We will be here ( Blaine ) with bells on
Go Sailing
Gene C Carter
PO Box 895
Blaine WA 98231
Cell (360) 815-5388
________________________________
To: amelyachtowners@...
Sent:
We will be here ( Blaine ) with bells on
Go Sailing
Gene C Carter
PO Box 895
Blaine WA 98231
Cell (360) 815-5388
________________________________
To: amelyachtowners@...
Sent:
|
By
Gene
·
#11697
·
|
|
Re: [Amel] Luff tape size for main and mizzen?
I see you in pink and green.
I DIDN'T KNOW you were from Miami. I'm counting on you being in Blaine.
Love,
Joe
Gene C Carter
PO Box 895
Blaine WA 98231
Cell (360) 815-5388
I see you in pink and green.
I DIDN'T KNOW you were from Miami. I'm counting on you being in Blaine.
Love,
Joe
Gene C Carter
PO Box 895
Blaine WA 98231
Cell (360) 815-5388
|
By
Joe and Martha
·
#11696
·
|
|
Re: [Amel] Luff tape size for main and mizzen?
Good day Hanoah64.
I have a Sharki Stargazer 1985 with factory roller furling
If you want a serious performance increase talk with Don Yager. He cut us s new mizzen and main with vertical battens
Good day Hanoah64.
I have a Sharki Stargazer 1985 with factory roller furling
If you want a serious performance increase talk with Don Yager. He cut us s new mizzen and main with vertical battens
|
By
Gene
·
#11695
·
|
|
Amel 54 Polar
I would appreciate it if a member could direct me to the polar charts of the Amel 54. Thanks. JP
I would appreciate it if a member could direct me to the polar charts of the Amel 54. Thanks. JP
|
By
galacsea2000 <no_reply@...>
·
#11693
·
|
|
Luff tape size for main and mizzen?
We are having new sails made for our 1985 Sharki #127. What is the correct luff tape size for these roller furling sails? Thanks, in advance, for any response.
Roger Wilson S/V Hanoah
We are having new sails made for our 1985 Sharki #127. What is the correct luff tape size for these roller furling sails? Thanks, in advance, for any response.
Roger Wilson S/V Hanoah
|
By
hanoah64 <hanoah64@...>
·
#11694
·
|
|
Re: [Amel] Authorized Amel Service Representative in Turkey
Well we haven't met Riza but we have had a lot of mail conversation with him. We have also seen the Emek Marin works on one SM and we are impressed.
We are planning to change part of our standing
Well we haven't met Riza but we have had a lot of mail conversation with him. We have also seen the Emek Marin works on one SM and we are impressed.
We are planning to change part of our standing
|
By
Ann-Sofie Svanberg <kanalmamman@...>
·
#11692
·
|
|
Authorized Amel Service Representative in Turkey
I learned that this year there were 63 Amels that visited Turkey and there are 2 Amels owned by Turkish citizens.
I also found an authorized Amel service representative in Gocek, Turkey. His company
I learned that this year there were 63 Amels that visited Turkey and there are 2 Amels owned by Turkish citizens.
I also found an authorized Amel service representative in Gocek, Turkey. His company
|
By
Judy and Bill aboard SV BeBe <yahoogroups@...>
·
#11691
·
|
|
Re: [Amel] Newby to Amel...
Re :engine and drive train cost of maintainance on the yamar 75 hp on sm
#349. If you have a reputable yanmar certified mechanic or yourself, change
your filters both oil and fuel at the prescribed
Re :engine and drive train cost of maintainance on the yamar 75 hp on sm
#349. If you have a reputable yanmar certified mechanic or yourself, change
your filters both oil and fuel at the prescribed
|
By
murray k. seidel <mseidel@...>
·
#11690
·
|
|
Re: [Amel] Re: Questions
In response to all prior questions regarding SSB antennae, I installed
Split Lead SSB antenna, which slides over the mizzen stay without undoing
anything. Cable ties hold it on and you apply these
In response to all prior questions regarding SSB antennae, I installed
Split Lead SSB antenna, which slides over the mizzen stay without undoing
anything. Cable ties hold it on and you apply these
|
By
murray k. seidel <mseidel@...>
·
#11689
·
|
|
Re: [Amel] Rudder cables
Graham,
Thank you for responding. I thought the same thing but the owner's manual I have for the boat mentions periodic lubrication. Maybe it was lost in translation?
Cheers,
Dave
Graham,
Thank you for responding. I thought the same thing but the owner's manual I have for the boat mentions periodic lubrication. Maybe it was lost in translation?
Cheers,
Dave
|
By
Dave_Benjamin
·
#11688
·
|
|
Re: [Amel] Rudder cables
Hi,
After the previous owner of my boat had to replace the streering cables which broke during a transatlantic crossing I was concerned with this situation since I was considering crossing my Mango
Hi,
After the previous owner of my boat had to replace the streering cables which broke during a transatlantic crossing I was concerned with this situation since I was considering crossing my Mango
|
By
Serge Tremblay <laetitiaii@...>
·
#11687
·
|
|
Re: [Amel] Rudder cables
Hi GrahamYou were up and about early on this glorious autumn morning. Re steering cables I found no method of lubricating them and was told by a pal with a Maramu that they were sealed for life, I'll
Hi GrahamYou were up and about early on this glorious autumn morning. Re steering cables I found no method of lubricating them and was told by a pal with a Maramu that they were sealed for life, I'll
|
By
spritoaffine
·
#11686
·
|
|
Re: [Amel] Rudder cables
Hi Dave,
Although it is a very long time since I used to install Teleflex steering systems I seem to recall that the cables are sealed for life and have a plastic/teflon type liner and lubrication was
Hi Dave,
Although it is a very long time since I used to install Teleflex steering systems I seem to recall that the cables are sealed for life and have a plastic/teflon type liner and lubrication was
|
By
GrahamJohnston42 <grahamjohnston42@yahoo.com>
·
#11685
·
|
|
Re: Rudder cables
Thanks Graham, Bill and Serge for your input re cable adjustment, it looks like not too big a job to add to the spring list
David
Spirito Affine
Sharki 148
Thanks Graham, Bill and Serge for your input re cable adjustment, it looks like not too big a job to add to the spring list
David
Spirito Affine
Sharki 148
|
By
spritoaffine
·
#11684
·
|