Hi all, My motor tmd 22 smoke very black after 2400RPM. I think i have a problem with wastegate of the turbo. I think the wastegate is locked in position Open. Is it easy to clean this gate ? Thank

There are some great threads from a few years ago regarding low rpm. Heres a list of all the things I can remember that were checked when I was investigating: Growth on hull or prop, autoprop that

Hi Alan by the sound of it the black stain on the hull would get me over board and clean the prop. Regards Richard Piller Cell 603 767 5330

we too have the same issue with Yanmar 100hp It will go to 1900/2000 rpm no problem and in slight seas maybe 2200, but no more... It is possible that the autoprop is dirty ..hasn't been cleaned for

When I told them about what AutoProp told me (that the prop I have was recommended for the 100HP) they said they had had no problems and put the same prop on all SMs with either the 78 or 100 HP

Has anyone gone back to Amel and asked the questions? Danny SM 299 Ocean Pearl Currently Fiji ________________________________ To: "amelyachtowners@..."

Miles We are having the same discussion with Yanmar about the RPM. We are repowering from the Yanmar 75 to the 100HP. This engine has a rev point of 3200 vs 3800 on the 75HP. Autoprop in Nerwport have

Miles, I spent several thousands of dollars assuming that the boat was propped correctly from Amel. I read and gave their explanation to every mechanic who worked on the boat. Fairly early in the

Hi all, Miles, is correct and yes 2800 is what we get at full that is Amels settings. Should you be Having problems getting there they can be many fold. Most of them come from well minded persons who

Good afternoon MIle, I agree this is hard to believe the Super Maramu could not exceed 2200 rpm out of the factory... Were you ever able to reach 2800 rpm? Last november had antifooling done and

Billie, I am interested in the B&G analog gauges. My contact info is below. Thank you. Roy Roy Duddy Duddy Law Offices One Liberty Lane, Suite 256 Hampton, New Hampshire 03842 603-668-9000

Hello all, I think that you will find that the boat is not "over propped as it came from Amel. Someone who says it is does not understand the boat. I bought my Super Maramu new in 1998 and Amel

All of the bearings! I want to have spare bearings, seals, o rings, etc. for everything. Thanks in advance! Alexandre --------------------------------------------

Billie, I am the owner of 2005 Amel 54 #31, currently on the hard in Grenada. I am interested in your RIB launcher. Where are you? I am also curious about your B&G analog gauges. What did you replace

Does anyone know the size or reference for the brushes for the Leroy Somer electric motor for the outhaul/main and genoa? Stocking up spare. Actually I am looking for all of the size of the brushes

Are you talking about the bearings in the lower unit connected to the propeller shaft? Fair Winds Eric Amel Super Maramu #376 Kimberlite _____ From:

Does any one know for sure the bearing sizes for the bow thruster? I want to stock on spare parts. Thanks in advance. Sincerely, Alexandre SM2K #289 NIKIMAT Seabrook, Texas, USA

--- In amelyachtowners@..., "Billie" <harlowx@...> wrote: > > I have a RIB launch and recovery system if anyone is interested.It has a roller setup which goes in the center removable rear

Yes - I would be interested too. Amel 54 #035 Goçek - Carango Peter Forbes 07836 209730 ppsforbes@...

Billie, I would be interested in seeing your rib launch system. Thank you, Gary S/V Bozo Cinq, Amel 54 #44