I have given this thread much thought and also done some reading since opening up this topic for discussion. I understand that our beloved boats were designed to have the negative side of the DC

Here here. I’ll second that. Merry Christmas Best regards, Mark SM2K #275 www.creampuff.us

All the best for the Christmas season to you all. It has been a pleasure corresponding with you over the year.Thank you all for your input. Danny and Yvonne SM 299 Ocean Pearl Mangonui New Zealand

Hi Pat, seems a number of us have the same problem. They are not in my spam folder either. Danny SM 299 Ocean Pearl

Graham, Are you in the US? I found a hydraulic supply place in Houston that had a good supply of BSP valves and fittings. What some people have done is just change the skin fitting so they don't have

I just sent this to Maud in LaRochelle and would be interested if any one had any comments. Dear Maud, A technical question. My SM no 140 has through hull fittings for the intake water in both the of

This morning is the first Amel related emails that I have had in about a week,and my spam folder is empty. Pat SM #123

Interestingly our previous steady flow of Amel site emails has recently ceased too. I wonder if this has something to do with the Yahoo site changes?? Will check my spam folder but don't think that to

I giveup, Photos areposted in the first Kimberlite photo section FairWinds Eric AmelSuper Maramu #376 Kimberlite From: amelyachtowners@... [mailto:amelyachtowners@...] On Behalf Of

_____ I am using the Free version of SPAMfighter <http://www.spamfighter.com/len> . SPAMfighter has removed 2589 of my spam emails to date. Do you have a slow PC?

HiDanny, I lookedat the amel yahoo page, and I seem to have received all of the messages. You can heckyour spam fighter folder to see if any of it is being blocked as spam. You justthen have to

Hi Eric, seeing this about spam fighter makes me wonder. We are getting very few amel owners forum emails recently, wonder if this has something to do with it . Regards Danny SM 299 ocean pearl

I willpost them to the photos section FairWinds Eric From: amelyachtowners@... [mailto:amelyachtowners@...] On Behalf Of Sailorman Sent: Wednesday, December 18, 20138:20

_____ From: amelyachtowners@... [mailto:amelyachtowners@...] On Behalf Of Kent Robertson Sent: Wednesday, December 18, 2013 7:57 PM To:

That link didn't work

kl14.jpgDCP01181.JPGDCP01179.JPG _____ I am using the Free version of SPAMfighter <http://www.spamfighter.com/len> . SPAMfighter has removed 51 of my spam emails to date. Do you have a slow

Greg, I was referring to the cutless bearing. We pulled the shaft out from outside after removing the prop.

Dave, Are you referring to changing the cutless bearing or the bearing in the stern tube? Did you take the shaft out backwards (towards the stern)? Greg Shea Sharki 133 Cap des Isles

Hi Greg When we had our cutless bearing replaced in Lagos in 2007 the yardfabricated a small item out of surplus bits of steel to take the weight of thepull when the bearing is removed, first grind 2

Greg, I think its probably similar to the Maramu. You will need to undo the coupler and remove the prop shaft. On mine, I found that none of the standard bearings were a good fit so I had to have one