Regarding your fuel gauge stick, I ordered a replacement from Maud at Amel (sav@...) and I came rather quickly by Federal Express in a long tube. Reference you model and hull number in your

Hi Alexandre. I ordered a set of bow thruster seals from Maud by emailing her at Amelsav@... Of course, you may write to her in french. Just tell her your hull number and she will give you a

I am traveling right now and don't have the invoice to hand, but I believe it was under $200.00 for the "machining' of the blades. Hope this helps. SV Libby SM#196 San Diego

Hi, simple way to check the waste gate is to remove the pin from the actuating arm and see if it turns easily. Keep the WD40/CRC56 going on it always. Regards Danny SM299 Ocean Pearl Lautoka Fiji,

Hi Alan, all us owners of TMD22 Volvos are grateful to you, its not just our volvo. If you have been stationary for any time in the 4 months since the clean your prop will be dirty and as Joel Potter

Hi Eric, no I have not yet tried this as I have no long enough leads. I will have a go in time, but in the meantime my relay mod has taken all the frustration and stress away. Cheers Ian SM 414

Thank a lot for help. Do younow the cable way of the 2 sensor?

If you look in the bottom locker just aft of the forward bulkhead (opposite forward dining table seat) you will find it under the shelf held up by shock cord. Ian Shepherd SM414 Crusader (2003) Nr

Hi Amelyachtowners, What Lockers ship is the sonic speed computeur? thank SM 192

Hi all, My motor tmd 22 smoke very black after 2400RPM. I think i have a problem with wastegate of the turbo. I think the wastegate is locked in position Open. Is it easy to clean this gate ? Thank

There are some great threads from a few years ago regarding low rpm. Heres a list of all the things I can remember that were checked when I was investigating: Growth on hull or prop, autoprop that

Hi Alan by the sound of it the black stain on the hull would get me over board and clean the prop. Regards Richard Piller Cell 603 767 5330

we too have the same issue with Yanmar 100hp It will go to 1900/2000 rpm no problem and in slight seas maybe 2200, but no more... It is possible that the autoprop is dirty ..hasn't been cleaned for

When I told them about what AutoProp told me (that the prop I have was recommended for the 100HP) they said they had had no problems and put the same prop on all SMs with either the 78 or 100 HP

Has anyone gone back to Amel and asked the questions? Danny SM 299 Ocean Pearl Currently Fiji ________________________________ To: "amelyachtowners@..."

Miles We are having the same discussion with Yanmar about the RPM. We are repowering from the Yanmar 75 to the 100HP. This engine has a rev point of 3200 vs 3800 on the 75HP. Autoprop in Nerwport have

Miles, I spent several thousands of dollars assuming that the boat was propped correctly from Amel. I read and gave their explanation to every mechanic who worked on the boat. Fairly early in the

Hi all, Miles, is correct and yes 2800 is what we get at full that is Amels settings. Should you be Having problems getting there they can be many fold. Most of them come from well minded persons who

Good afternoon MIle, I agree this is hard to believe the Super Maramu could not exceed 2200 rpm out of the factory... Were you ever able to reach 2800 rpm? Last november had antifooling done and

Billie, I am interested in the B&G analog gauges. My contact info is below. Thank you. Roy Roy Duddy Duddy Law Offices One Liberty Lane, Suite 256 Hampton, New Hampshire 03842 603-668-9000