Bill, Thanks for the excellent research. There are very correct assumptions to your investigation. Thanks again Dimitris Alma Libre Too Sent: Sunday, November 20, 2011 8:56 AM To:

Hi, I fully understand that now... the capacitors are the answer never leave home without spares.. Richard SM 209 For Sale in Annapolis. ________________________________ To:

We like the off shore route given that there is a cold front that blows NE about every three days this time of year, and most of the inlets along the coast require local knowledge to enter one and two

Thanks Ian, I will try that when I get back to the boat. We are back home in Norfolk Virginia, taking a break ."Moon Dog" Is on the hard in Venezuela, also getting a rest. We have almost completed

We have sailed down to Florida (the Keys/Ft. Lauderdale) a few times. We pretty much always stay inside the stream. We feel that we can check out the different areas along the coast (we love

No, 1 - after some time (years)_the thermal switch failed_ (low cost switch) and for the aft cabin it is the third replacement !! 2 - the capacitors value after some time decrease an the fan can

Thanks for the post. We just left Cape Charles, VA on our way South. still checking weather etc before we make a final decision. Cheers, Veit ATMAN SM 215 Sent from vm iPad

JLuc, Thank you for your participation on this posting, the previous information that you posted, your photographs, and the temperature range of the thermal switch and fuse. From my experience with

For your information on Cottonbay we use all the 3 heating positions witch 3 fans position and it works well. In the Clima heating box there are two things 1- thermal switch that regulate the air

Jose, Two possibilities, based on what you said: 1.) Is it possible that one or more of the foam seals were in the wrong place. In a set of 3 seals. one is made of a substance that is different than

Richard, Yes, the fan needs to be set to HIGH when in the heat mode. My point was that the fan was NOT running at HIGH speed when set to HIGH because the fan speed capacitors (CM, C1 & C2) were not

Well, we do have a mystery here or what? I would have agreed with Garry that the two seals on the bottom should do the trick, particularly if they are pressed against the flat fiberglass surface of

Hi according to the heater manual the electric heater fan ALWAYS needs to be on high. To keep it from turning off. Regards Richard Piller Cell 603 767 5330 [Non-text portions of this message have

We arrived in Beaufort, NC yesterday afternoon after a 32 hour sail from Hampton, VA on the "inside" of the gulf stream around Cape Hatteras. We stayed within a few miles of the shore, avoiding most

Check the hydraulic fluid in the gear perhaps the pressure is not enough perhaps there is a leakage in the hydraulic hoses Dimitris Alma libre too Από το iPhone μου 19 Νοε 2011, 0:36,

I have done it a number of times. Amel told me to do it when I bought the tool in France when I received Kimberlite Fair Winds Eric _____ From:

Bill, I replaced the heating coil and attached thermal switch some time ago. I will try replacing the capacitors. This made no change. Fair Winds Eric Amel Super Maramu #376 Kimberlite

Thanks, Bill and Eric.  I'll give it a try.   To: amelyachtowners@... Sent: Sunday, November 20, 2011 2:02 AM Subject: Re: [Amel] Amel Bow Thruster Tool   Kent, Put 1 wrap of

Won't it prevent the shaft from coming thru the lip seal? From: kimberlite kimberlite@...   HI, You put the tape at the joint where the tool joins the bow thruster. Electrical tape is

Hi Eric, When we had a Climma heater failure I corresponded with the Climma boss who told me that I should always run the heater on Max otherwise it will burn out. Ian and Judy, Pen Azen, SM 302,