Hi, Thanks, that is the fixture on the mizzen mast The foredeck light is different. Do you have any idea who makes that one. It has a retaining ring that holds in the same bulb as the mizzen mast

I think it is Aquasignal. Check out Budget Marine under Mast Flood Lights. John SM 391

Hi we just used the same SEW Clean it work well WITH one BIG problem it cleaned the seal off our ball valve so that it no longer not a big deal except that when in port we can nolonger use the forward

Hi Eric. The foredeck light is a sealed beam unit the same as the one mounted on the mizzen and is used in light aircraft and can be usually purchased locally.

getting too lazy to anchor / de-anchor manually... does anybody have experience / opinion about installing a electric windlass in a Euros 41 ?

Hi, Did you test the springs with a magnet to see if they were steel or stainless? Most of the lip seals I have found have steel springs Fair Winds Eric Amel Super Maramu #376 Kimberlite

Hi, I have a standalone AIS unit that looks like a radar screen for sale. Simple hookup. Fair Winds Eric Amel Super Maramu #376 Kimberlite _____ From:

Does anyone know the manufacturer of the foredeck light mounted just below the steaming light? Fair Winds Eric Amel Super Maramu #376 Kimberlite

Kent. The endura is rated at 10,000 pounds with a 1 percent stretch at 30 percent of breaking strength The xls is rated at 5900 pounds and has a 2.9 percent stretch at 30 percent of breaking

Dennis, I actually have 2 Nasa units I want to sell. On is a AIS black box for a chart plotter, the other is a stand alone unit that looks like a small radar. Fair Winds Eric Amel Super Maramu #376

Kent when you replace the line no matter which you choose leave some slack on one end AFTER the knot so you can take any strech after some use. Once we did that we have had good success Good luck.

Hi again, everyone, I'm going to replace the outhaul line and jibcar lines on KRISTY and was lookin back over this thread from a year ago. Eric recommended 3/8" Endura Braid by NE Ropes and Richard

All good advice, Craig.  Already working on the gear boxes for furlers/outhaul.  Hmmm, I guess if you aren't concerned enough to carry spares, maybe I should bag it, too.  Sure would save a lot of

Got it.  Thanks.  I guess they figure if it's on a GPS sending signal to multiple instruments it might not be as accurate???  Go figure. Have a great summer. Kent

Dennis there are a number of stand alone units available take a look at the Defender site for best price and selection. We successfully use a unit from NASA hooked via solider to the VHF ant and the

Dennis there are a number of stand alone units available take a look at the Defender site for best price and selection. We successfully use a unit from NASA hooked via solider to the VHF ant and the

Hello Casper and Vito, I just refurbished my furling gearbox and I'd be quite sure that the grease you're seeing from the bottom of the furling drum is because the seals are failing in the gearbox -

I have been advised that the Furuno chart plotter on my 2003 SM has Navnet 1 software installed and cannot accept an AIS receiver. Can anyone help a i frequently sail through high density traffic and

Hi Kent, Glad the info is helpful - good luck with the project. Here's a couple of afterthoughts: most important is to absolutely take this opportunity to open your jib furler gear box and

Ok here is the explanation. The AIS B is required to have its own GPS since the boat it is mounted on might not have a GPS. The GPS dome does NOT transmit it locates my boat and sends it out vis