Thanks, Richard. I will check out the Reya/Dolphin web site. If you happen to be on board in the next couple of days and can give me the model no. that would be great. Cheers, Ian and Judy, Pen Azen,

We replaced the Amel supplied chargers with one smart Dolphin unit that accepts 90 to 260 volts 50 or 60 cycle. It has worked well for the last 4 years both with shore power and the Gen set. We have

Joel, Thank you for your two replies, very useful. I have looked up the web site for Rydlyme Marine and have contacted them. There is a potential supplier in Tortola. Would you be abble to give

Hi Ian & Judy, yes it is the galley sink mixer tap. My second boat has a better model than the original (three before yours) in that there is a pull out flexible hose with a spray button that is

Hi y'all, An electricity spike in our Spainsh marina damaged our 25 Ah Dolphin charger made by Reya and fitted originally by Amel in 2000. The local dealer has now told me that the charger is

I believe that this is true here in France. When I first read it, I was a bit shocked, but I think it may be an EU-wide issue. I wonder if you could avoid this by a change of residence. There is

Dear Cotton Bay: How about adding some comments to your photos so we know what they are? In the Photos section you will see a comment window, Just type in some descriptive information. Or better

We did both with great success. Regards Richard Piller

For the latest regs you may want to take a look at "noonsite" on the web. They are very good with that kind of info. Regards Richard Piller [Non-text portions of this message have been removed]

Duh. I forgot to mention www.rydlymemarine.com <http://www.rydlymemarine.com/> for cleaning out the raw water system. I have prepared many experienced Amel boats for resale here in Fort

If your boat is like my 54 #14 you will find that the voltage coming out of the controller to the pump is indeed 12 volts. When put in a high load situation, as with a warm load of stuff in the

An accountant here mentioned to me the other day that he understood if a UK registered vessel was taken out of UK (or EU) waters for a period in excess of three years from the date of its departure,

Our Amel 54 #56 is tited with 3 refrigerator units cooled by a Climma salt water pump and controlled by a Climma control unit in the engine room. We have recenntly had a failure, I thought of the

About a year ago I put Sew Clean in my toilets,hoses and the bottom couple of inches of the holding tanks, to insure it filled the outlet hose. This product is especially designed for black water

Hi Bill thanks for the " heads up" when we are in places for more then a few days we run fresh water into the sea chest to keep stuff from growing and limit salt buildup. I guess " fresh clean" water

I know that we have all forgotten to flush the salt water out when leaving the boat unattended for more than a few days and returned to smelly water when operating the heads. Many of you may have

To all, first thanks a lot to all for help and suggestions . Short story : After a terrible Screech, Screech noise I explored the bottom of the motor where there is the connection with the black

Hi Garyl, the first time the furler jammed on the previous boat the headsail was half furled and we were in mid ocean 600 miles from any where. Luckily there was light wind at the time so we

Danny and Yvonne Hi guys: Can you be a little more specific about the process. Do you take a hose aloft and flush water down thru the furling foil on the jib/headstay? Do you then apply grease to

Hi, on a previous boat I found that salt is a great enemy of furler rollers.. Had one sieze up in mid ocean, couldnt move it either way. Un wrapped the headsail by hand, droped the sail and flushed