Does anyone have experience using the 4 deck level lifting points to lift a Super Maramu? Because of the recent change in Pirate activity and the unrest in Egypt, we are considering transport via

Thanks. Regards Richard Piller

I attach it to the bonding clamp on the gas fill in my starboard cockpit locker. That is also where I stow it when I am sailing. At anchor the wire fits well under the locker gasket and I tie the

Eric, what to you attach the boat side of your zink too?? Richard SM 209 ________________________________ To: amelyachtowners@... Sent: Sun, February 6, 2011 5:23:01 PM Subject: RE:

On mt Amel Super Maramu #376 Kimberlite the engine is disconnected from the ground by a gold Valeo contactor except when the engine is started. My engine is not grounded. However I always hang a Zink

Hi Fabio and other "Santorinians", your info are toooo interesting to me for my future (not so near) plans. What I think to add is only this: 1. liferaft: when I was in Hyeres I planned to locate

Hi, Ian and Judy, it seems you have moved on to sunnier climes since our meeting in Tobermory last July. We cruised the Med for 30 years from Gib to Greece and only used Camping Gaz bottles. The

When we are last in the Med. we bought the "blue" butane cans of gas and a reg. with and adapted it to our "propane" system. That worked rather well. Fill US cans is not even thinkable in the

Hi Mike & Chris, thank you very much for your precious information and suggestions. Italica SN 28 and Akwaaba SN 27 are sisters, I think they left Amel shipyard more or less in the same time! Where

Hi y'all, In the last few years, spent in South America, we have used UK gas bottles. We have refilled these where possible, either with propane or butane. Most countries in South America

Hi Ivan, sorry for dealy in answering but I had a programmed surgery and was involved with different problems! Now is over! thank you so much for all your suggestions and precious experience

Hi John, I have also replaced my original unit with the CR130 Refrigerator/Freezer. It does a good job of making ice even though the freezer compartment is small (they also make a Drink version

Hi John, on my Santorin I have a INDEL MARINE Isotherm fridge, made in Italy, installed 2 years ago. Have a look at:

Put a volt meter on the shaft and ground it to the engine. If you get a reading check the engine ground first. You may also get the sinks on the prop working against those on the rudder. You might ck

The new impellers for the yanmar on the Amel Super Maramu has a built in thread. There is a 20 dollar tool from Yanmar that you screw into the center of the impeller and turn the screw with a

Hi , Do you have an autoprop or a maxprop? Fair Winds Eric Amel Super Maramu #376 Kimberlite _____ From: amelyachtowners@... [mailto:amelyachtowners@...] On

My max prop anode on SM140 has recently been suffering from excessive wastage. She is not in a marina or plugged in to shore power. The 2 anodes on the rudder are performing "normally". The only

Thanks Miles. Regards Richard Piller [Non-text portions of this message have been removed]

Virus Warning!!!! This has nothing to do with shower faucets, but I want to alert the community to a possible threat. Last week, someone posted a reply concerning a video concerning the bow

That sounds good to me, Eric.  If all goes well with my engine swap, I should be ready to leave PR by Feb 28.  I was going to Antigua, but perhaps a quick rendezvous in St. Martin could be