You do not need to go to a "marine" store to buy this. Buy it in a water well pump store. Buy one twice as large as what you have and have them set it for 40PSI before you leave their store. You

Thank you, Veit

Hello Alex. From memory, which seems to become a more endangered resource every day, the Maramu battery bank for the house is charged by the charger when on shore power when the switch is placed in

Just to clarify, our Maramu has no genset and both battery banks are 12V. There are 3 alternators: house and engine banks and the shaft mounted alternator. We have and Air X wind generator and 2 x 65W

Mine also rusted out. This seems to be a very stock item, I bought mine at budget marine in St Martin Fair Winds Eric Amel Super Maramu #376 Kimberlite _____ From:

Hello All: We have (had) a white expansion tank in the fresh water system mounted right behind the water heater. It is (was) connected with a single hose to the manifold on the pressure side of the

The house bank on my Amel is 24volts (12 group 31 batteries) .It is charged by a 175 amp 24 volt lycee-neville 24 volt alternator on the yanmar engine. Or is charged by either the battery chargers

Alex your post said Maramu is it a 12 volt boat or 12 and 24 volt. The solution suggested earlier assumed all 12 volt. If you need both 12 and 24 you'll need tow chargers. Regards Richard

Alex: One major thing to look out for is the difference in voltage between the two banks. On our SM, the engine/genset starter battery is 12VDC and the house battery bank is 24VDC. Is that the same

Hi Alex normally when you charge more than one batt bank you install a device to manage multiple banks. That every bank gets a proper charge and you don't over charge. We did it on out Maramu

Alex We have replaced all the plexiglass to the side panel windows and the hatches. John is sailing in Ireland at the moment He will be back tomorrow and I will get him to give a more comprehensive

Hi when you remove the plexie glass sides ports be sure to full each of the scrw hole mark each panel over lay each panel on the new plex mark and cut out with a fine blade saw the sand and polis the

We are planning to replace our Maramu side plexiglass panels and remove the four hatches and re-install. Can anyone having done this offer any advice regarding our intended project? - Adhesives

We've installed a new Mastervolt 40 amp charger onboard our 1981 Maramu which still has it's original electrical installation Does anyone know what are any negative consequences of connecting the

Not that I know of in SoCal. Joel F. Potter Cruising Yacht Specialist. Amel's Sole Associate For America. Sent from my iPhone. Office: 954 462 5869 Cell: 954 812 2485 [Non-text portions of this

We may be purchasing an Amel Super Maramu 53 in the near future. Before committing to a trip overseas it would be great to see one here first. Is there someone in Southern California with a 53 that

Cheers Danny Thank you. Best Regards Barry Tradewinds III SM #171

Hi Barry, the copper was very corroded so was not able to tell. However the outlet tube of the tank is not tapered. The fitting you are going to try I imagine has a spear on one end and is threaded on

Hi Bill, thank you for your reply. I read your post previously. The copper tube is eaten away and has to be replaced. Thank you all the same. Best Regards Barry Tradewinds III SM #171

Hi Bill, there must have been a change between 299 and 387, my outlet is copper not bronze, hence its failure I guess. Thanks for your clear and helpful posts. Enjoyed reading your blog re loading Be