Greetings all. I have a 1998 Amel Supermaramu #230. Guests who have stayed with me have noticed a very annoying noise problem in the forward head area. I wonder if anyone has dealt with this: When

Hi everybbody, In know the same problem for almost 5 years (Caramel SM2000 #329 May 2001). I dedided to replace the manifold this year and asked Amel to build a new one. Take care, because there are

Gary, got it. Thanks. Eric Amel Super Maramu #376 Kimberlite _____ From: amelyachtowners@... [mailto:amelyachtowners@...] On Behalf Of amelliahona Sent:

William, I had the exact same problem in the exact same place. It must be some stray AC coming from the pump. However, I am hesitant on grounding the pump. That would put the stray AC in the whole

I have a general question about corrosion in the seawater manifold. In May this year the seawater intake manifold on our Super Maramu 2000 (7+ years since new, 5 years at sea) developed a leak.

I recently had my rigging checked on Minaxi SM6. The boatyard suggested that the rig was too tight, in fact they said it was tighter than any they have seen on similar size boats. Before gong ahead

Sorry Eric. Let me try again. Please see the photo labeled Outhaul Drive Shaft #2 in the SM Outhaul Service Folder in the photos section. The shaft is shown in the removed condition.

Gary, Sorry I don't quite get it. Eric _____ From: amelyachtowners@... [mailto:amelyachtowners@...] On Behalf Of amelliahona Sent: Friday, July 18, 2008 11:48

Hi Jorge: I have not removed the motor yet. I pulled the parts off the boom just as we were preparing to put the boat on the hard for the hurricane season. I stowed the disassembled parts below

Eric: The link that I posted shows the puller with the jaws and puller bolt pointed downward. In the case of the shaft on the outhaul this was inverted so that the puller bolt (in the center of the

I put the whole part into a hydraulic press and with a pin smaller than the shaft pushed it out. It did take quite some force but it came out clean. Udo SM #50 Cloud Seven

Gary, to what did the machinist attach the straight jaw puller ? thanks Eric Amel Super Maramu #376 Kimberlite _____ From:

Hi Gary Thanks for your prompt response.. One more question... Is there any trick in pulling the gear box from the motor shaft after I take the retainer?. Thanks in advance Jorge

Hi Jorge: I have recently removed the outhaul gearbox from the boom. I have posted some pictures of the gearbox in the photos section. This was a tough job but the boom did not need to be removed.

Dear Members I am considering replacing the two gear boxes of the main sail furling system on a SM-97 model. Does any body have any tips on this job? Amel told me that I have to take the boom down.

Richard, That is a great suggestion and solution. We have been very frustrated in our attempts to obtain the original equipment. On another matter, could someone please give us the length of the

Hello All, My chain counter has stopped working—again. Last winter I replaced the sensor and doing this solved the problem. Now the display just shows 00 and does not count. The sensor and the

Hi, we have used the same rubber as used in "wet suits" and built it up to the same approx. thickness. We also used it seal the bow thruster, double seals on the outside of the shaft to keep the

Hello Jim, I think you ill find a pic showing the drive unit in the photos section in the " changes to Bali Hai" album but it is probably not good enough for your purposes. Regards,

<jim.dernehl@...> wrote: Hello Jim, I am in the same situation as you. Patrick has installed on his "Caramel" a 2nd motor in the cupboard above the pantry. I think, I will have Raymarine doing a same