I have been unable to locate the cloth-like tape Amel wrapped on hoses under worm clamps throughout my SM2K. I've been using electrical tape when replacing it, vaguely worried I may be doing

Ian We encountered the same concerns as we sail in Maine during the summer time and the spurs are too small and zinc repacement is constant. We ordered the following line cutter Shart Shark Cutter and

Hi y'all, We have had Spurs rope cutters on Pen Azen ( SM 302) for ten years. On a couple of occasions we have encountered fairly thick rope and the fixed blade has just snapped off. Spurs

Hi y'all, We have had Spurs rope cutters on Pen Azen ( SM 302) for ten years. On a couple of occasions we have encountered fairly thick rope and the fixed blade has just snapped off. Spurs

Eric, The slit was the width of the sawblade. The material is flexible enough to work with so you just need the one cut. We've had ours on for over a year and they still look fine. We came back

Dave, I was thinking of that, However how long does it hold up in the Caribbean sun? Did you cut a very small slit ? or what size,? What did you seize it with? Fair Winds Eric _____

Available at any hardware store.....PVC pipe I use a table saw to cut a slit. After installing I seize it every 500mm or so.

A couple of years ago we found the larger diameter plastic rigging covers in a chandlery in Le Marin, Martinique. I don't know today if they still have those larger diameters. But Amel-Caraibes

Steve, I store mine in the port cockpit locker all the way forward in the original bag. Next to it I have the chafe gear. I packed it in such a way that the bridle is on top and then I drop in

no where in the Caribbean and in the US, West marine and Defender says no too. I gave up. John "Moon Dog" SM248 To: amelyachtowners@... From: kimberlite@... Date: Thu, 16

Thanks Eric, Based on your earlier accounts and recommendations, I bought a Jordan series drogue before we left on the 2009 Caribbean 1500. Like the life raft, hoping we never have to use it, but

Does anyone have a source for the large diameter plastic rigging covers in the USA or Caribbean? The smaller stuff is readily available, although it only lasts about 2 years in the strong sun. Fair

Steve, The initial problem with retrieving the drogue was that the primary winch motors are not rated for continuous duty. After overheating the motor a few times, I just waited about 1 minute every

Sorry it was freefall

Lower in the text is the link shot from one of two rescue helicopters. Fair Winds Eric Amel Super Maramu #376 Kimberlite Here is the

I did and Google didn't Roy Duddy Duddy Law Offices 500 Commercial Street Suite 401 Manchester, NH 03101 603-668-9000 603-606-2756 Fax rduddy@... [Non-text portions of this message

When a breaking wave comes towards the boat you are going to get wet. We were pooped at least once on every 3 hour watch. One time the water was up to one of the crewmembers armpits, however the

Eric, I remember in one of your earlier posts you described how difficult it was retrieving the Jordan series drogue, and that it kept throwing the circuit breaker on the genoa sheet power winch.

Was there any water was coming over the stern at the time. What was it like on board? ....CW ________________________________ To: amelyachtowners@... Sent: Wed, 15 December, 2010

On the drogue you run under bare poles, our speed was about 1 ½ knots down wind. You adjust the angle of the boat with the bridles until you are square to the oncoming waves. In Force 12 wind you do