Anne and John Hollamby, I have photos of both pumps which I will post in "Dessalator Water Maker Service" in the photo section of this website in about an hour. I will attempt to get you sizes of

I would also check the voltage at the connection for the control head at the course computer. It should be 12 volts. Only the drive motor works on 24 volts, the clutch is also 12 volts. Fair

Yes Richard I googled up Trinadad and found the price in the US was Xy as well. I also found a site here from the government pesticides & vetinary authority recalling all Trinadad antifoul, it diddn't

Hello, My wife and I have an accepted offer for a 1985 46' Maramu Nirvana Ketch. It has mostly original equipment and rigging, including the electric furling on the head sail and main. This weekend

Has anyone replaced the Clima A/C unit with a different unit? We are contemplating Cruise Air. George Cerillo #353 Indecent

Hello, We are contemplating replacing our Clima AC units for Cruise Air, due to the fact that we have 2 compressors that are shot. Does anyone have any experience replacing the Clima units with a

Thank you all for the suggestions. We will be purchasing the corrosionx and hope that will fix the problem. Certainly don't want to replace the autohelm! I will let you know how it goes.

Thank you for all of the suggestions. We Judy and Bill aboard SV BeBe <yahoogroups@...> wrote:

Hi Bill, I had my LP Pump serviced by Dessalateur at huge cost. It has come back without some of the fittings to the four ins and outs and I am not sure which one does which. Please tell me

Hey, I just realized that you were asking for a 220 volt pump what I had suggested was a 24 volt pump.. I don't have one with me now but if you look on the "Budget Marine" St. Martin web site they

Hi Bill, we use a Surflo controlled pressure pump before the high pressure pump it has a rate of 3.2 gal per min or 192 per hour at 30 psi.. with an auto shut off if pressure goes to high. That

Conn, you are not alone on the price issues, we have seen bottom paint from US$400 down to 225 for the same can of paint.. Be advised and look around..... We don't see Altex X here in the US or

well if they did not - they do NOW!!!! BTW FYI When we last anchored in CC in April MOORSECURE had just laid 6 moorings in the east side of the anchorage - that was one days work and we left

Does anyone have the specs on the 230v low pressure pump on the 160lph water maker. I am looking for gallons/hour or some such water flow spec to be able to buy a spare/replacement pump. I emailed

Thanks again Richard. Our old boat was a 30 footer so I diddn't know how much to order for the larger size. 5 gallons here  costs over 1000 bucks so I diddn't want to over order. I don't know if I

We us two coats after sanding with rough grit paper. Given you have a Mango be shore to check for blisters. If you have them take care before you paint. Paint does not hold well to blistered areas.

Thanks Richard, do you apply 1 or 2 coates. ________________________________ To: amelyachtowners@... Sent: Tue, June 1, 2010 9:59:52 PM Subject: Re: [Amel] Anti foul   We generally

We generally use 5 gal Pettit Trinadad SR on our SM. Richard SM209 Sent via BlackBerry by AT&T

We haven't had our Mango for long and I am slipping it soon. Just wondering about how much antifoul paint I might need.

I've been assigned an AU extension, so that's Email jloosehoe AT yahoo DOT com DOT au Regards Jack