We had the same problem and since we are in France we tried to source the parts to repair same. The company that made the original bilge pump was sold to REYA. I tried contacting the company in Italy

Two years we hauled at Power Boats and had excellent work done by several workers and we would like to return for a haul out and bottom job plus other bits of work. At that time there were at least

Hi Roque, I am insured through Topsail Insurance brokers (agents for Navigators and General (The trading name for Zurich Insurance PLC). I have used them for the last 7 years, ever since Pantaenius

Joel, While we are on the subject, what do you think about washing the turbo with soapy water as suggested by yanmar? Fair Winds Eric _____ From:

Hi, Take a look at the photo section, you will see a melted muffler on Kimberlite Fair Winds Eric Amel Super Maramu #376 Kimberlite _____ From:

Hi Joel, Thanks for the detailed response. I'll follow up on your suggestions shortly. Lorado/Doodlebug/Northfork is holding up quite well. thanks, Mark

Hi, I have been trying to find the link to the old black and white Navy (NMOLC?) gulf stream chart. Anyone have the link ? Fair Winds Eric Amel Super Maramu #376 Kimberlite

I have spoken to the Climma dealer a few times and he is also stymied about the problem. Fair Winds Eric Amel Super Maramu #376 Kimberlite _____ From:

Hello Mark, I have addressed these problems in the past with other clients. In order of probability, I will let you know what to look for. Some of the tests are destructive in nature and for that I

When we first bought our SM #248, we tried the Thomson Australe in wash plus dry mode and found it did not work well at all, and took a very long time, especially if on the genset. So after that, we

We use Assurances Maritimes de Lessee/Groupama. Pantaenius refused to cover us in certain areas of the Indian Ocean, Gulf of Aden and Red Sea. Hurricane coverage is very strictly written in the

Kent, Thanks for reply, Iam short on time and I think I will leave it bronze. Pat

Hi, Pat. I did not have mine chromed. Check with a motorcycle shop. They do a lot of chrome work. Kent SM243 KRISTY Sent from my BlackBerry® smartphone powered by Alltel

Hi everyone. I have read a lot of previous posts about insurance and started asking for quotes. It is now narrowed down to 2 providers: Pantaenius (Mr. Keefer Ascher from Mallorca) and Assurances

Kent, I could not find your email address so Iam posting this assuming you will read this.I know you had a turnbuckle fabricated for the forstay, I assume from bronze. I and a friend just fabricated

Eric if you detour to the Chresakeake we get it going for you. There is a stocking dealer just up the road from Annapolis Regards Richard Piller "Yacht Brokerage Service above and beyond the

Eric I assume you have a digital voltmeter set for condenser test and check them the hard part is getting to them. Turn off the power, discharge each cond. Then check if you get zero or a lower number

Hello, I'm going crazy behind the washer dryer: Do not over dry clothes. The drying cycle begins, but after 2 hours I take off my clothes in the same wet way, and even cold. Does anyone have any

I have my mast down to re-rig and also need to remove the furler swivel so I repair/rebuild it. I can not figure out how to get the gear shaft removed from the mast so I can slide the swivel off the

Richard, The ducts and coils are very clean. The heater runs for about 3 minutes then shuts down and does not come on again unless I turn off the thermostat wait 3 minutes and start over again. At