Does anyone have digital files for the the Amel decal on the cabin sides? Bill Reynolds Cloudstreet SM2K 331

Bernd, My reply is not meant for you but for all of those owners who are new to an Amel made prior to the Amel 55. If you use the shower for anything in addition to showering, you will find that this

On our SM, starboard cockpit locker. It was quite annoying until I cut a semicircular hole in the lip so I can have the hose out, on and coiled nicely and still be able to sit on the locker lid seat

Hello, Where is the deck shower installed on your SN or SM? On my SN it’s in the port cockpit locker which is sub optimal... Rgds -- Bernd SN 119 / Cascais, Portugal

Thanks much, Nick. Joerg

Matt, As it relates to this, seems you're light years ahead of me! I don't need a wide nor a long range, in fact, I want it to only cover the transom area or perhaps the lazarette area. The Digital

Could you send a pic or the model number? Have you ever considered angling it or putting tape on the sensor so that it only covers the transom forward? My understanding is that PIR sensors don't

Greetings all, While cruising Mexico’s Pacific coast this year I had the Garmin Pan optic PS-51 forward sonar start to behave irregularly and ultimately overheat and fail. Garmin replaced it on

We have a motion activated solar light on the arch. It works well. However, the motion sensor is sensitive. You must ensure there is nothing back there to constantly trip the sensor. If you keep your

My old one did that, too. Super advice, thank you and thanks for the photo, too- super helpful. -Tim SM2K #306

Scott, I am still building my marine experience, so you are far ahead of me. From a terra-firma perspective, motion sensors are used for their greater range verses IR sensors. IR sensors tend to get

Matt, My understanding was that passive infrared sensors, the type normally used, detect heat emitted by humans/animals, not motion. Some of them have sensitivity adjustments too, just haven't been

I think all of the B&G Hydra depth transducers installed when SMs were new were 38mm. B&G makes a 51mm 2" depth transducer that is also forward looking sonar. Something to think about with a new B&G

One more thought on this. It is a good idea to add washers tothe screws holding on the deck light part. My new one was slapped with thehalyard and came apart (made in China). The screws pulled through

Hi Tim, Mine fitperfectly and the holes aligned. 3 wires – easy peasy. It is mounted with pop rivets.I carefully drilled out the old ones and had no issue getting the new one to align.

Chris, I cannot speak to your hull number (we need Bill's expertise). We are hull number 209. The AMEL installed transducer at the fwd head is 38mm diameter. The new transducer (DST810 and DX900) is

I am changing my navigation electronics at the moment. I ordered the Airmar UDST800, no moving parts, less power consumption than the DX900 (125mA instead of 400mA) and i think as cruiser i don't need

Matt- Thanks for the reply- So, from your experience you think I will have to replace my ST850 P17 houseing to accomidate the DST800 I linked or the DST810? It says ut us a 2" houseing. Chris

OK, I made a mistake. I bought the light listed below to replace the Deck and Steaming light: Aqua Signal Series 43 Masthead/Foredeck Mast Mount Led Combo Light - 12v/24v - White Housing SKU:

I bought the same light for my steaming and deck light, but have not installed it yet. It will not fit the same holes, and due to the fact that the SM has the Deck light mounted lower than the