ref AM54 : Hi all Amaliens, the oil-pressure-struts which open the cocpit windows have lost their oil. Can anybody help me with advice : can they be refurbished and refilled, and can i do this

Thanks Nick, Now I get it...interesting idea... Cheers Alan Elyse SM437

Eric, Shiny! Pretty! May you have many thousands of happy, and reliable, miles with it. Bill Kinney S/V Harmonie Hollywood, Florida, USA

Alan Apologies for the late response. I hope there help, let me know if there is anything else that might help Nick SV Rascal SM 404 Antigua Sent from ProtonMail Mobile

Just my tuppence worth..... Under the salt water, the RF (SSB) ground and the bonding to the zincs are electrically connected through the salt water. I can't see it would make any difference which one

Hi Marc, Here are some photos. Fair Winds Eric Kimberlite Amel Super Maramu #376

Hi Mark, Thank you, I am using the same setup that was on my old Yanmar. I just had to take off the serpentine belt and change the pulleys to accommodate a V belt. Since the alternator that came

Hi Eric, In case you need a new tensioning bracket for this alternator and engine, I found that the Balmar Belt Buddy w/Universal Adjustment Arm fits and works fine. I just had to

The vessel does not have an RF Found other than the SSB Ground. Best, CW Bill Rouse Amel Owners Yacht School +1 832-380-4970 | brouse@... 720 Winnie, Galveston Island, Texas 77550

Hi Bill, the Raymarine AIS installation manual states: The AIS700 includes a dedicated grounding point to reduce potential damage caused by near lightning strikes. The Grounding point should be

Hi Mark, Thank You for the photo. Fair Winds Eric Kimberlite Amel Super Maramu #376

Hi Steve, Thank you for the photos. Would it be possible to take a photo from the lower inboard side of the alternator. I need to see where they placed the spacers of the feet of the alternator

Hello Everybody I found the solution myself and happy the share it with the forum for those who are scratching their head like me ;-) Accessis possible from the portside front

Dear Amelians The Bosch Washing machine on WASABI is dripping the fuse and I want to remove or replace it. I tried to pull it out but something is holding it at the back where I have no access. I

Bill, The use of "chips" programmed with internal software (also called firmware) is wide spread these days. Security fuses inside these microcontrollers dictate wether a third party can read the

Hi Eric. Mounting on my Leece Neville . regards steve Dusk sm378.

Bill, Back in August, while running system checks, I discovered my Onan wasn't working, and the PCB board was the cause. After a worldwide search, and the explanation (by Onan) that their supplier had

Installing a 24 to 12 volt convertor for this is like using a sledgehammer to kill a fly. It WILL work, but is an insanely complex and expensive solution to a REALLY simple problem. I am a very big

Eric, Here's a pic I found of my Leece-Neville alternator mounting feet on my Yanmar 4JH3-HTE: I can't tell you if it is correct or not but this is the way it was when I bought the boat in 2017. --

I don’t know anything about this specific system, but is the clutch a simple ‘on’ or ‘off’? If so, you could use a simple 24v relay using it to switch 12v to the clutch (assuming you can