Hi all, The mechanic here in Licata on Sicily was until now not capable to get the gearbox and the motor from the boom. First he tried to push it upwards with a jack and later he tried to pull it

Hi Ruedi, from my point of view on your issue, I recommend to get in touch directly with VECO, the OEM of the fridge and cooling systems on our boats. The company is located in Italy and are well

Hi Thomas Thank you for all the useful hints. I still get into more detail’s with your information. You are right with the Engineers changing expensive gas and drinking your coffee 😉 BTW:

Hi José, Please advise your equipment details – for example, model number. And preferably advise also what, if any, software/firmware updates have been made since initial installation. Regarding

Hi Ruedi, My pump were all running well. I first took the dock water, very high pressure and forced it through the raw water tube from the pump. Lots of stuff came out on the water line. I could see

Hi Randal Thank you for your advice. In my case the cooling pump is running well and constantly. So there must be another problem with the freezer and it seems that it is the blocked filter or

Hi Barry Thanks for your advice. On WASABI the pump is running well and the raw water lines are clean. Therefore the fridge has another unknown problem? Very Best Ruedi SY WASABI AMEL54 #55

Here's a photo of the early model Super Maramu genoa furler, for which there are no parts or rebuild kits that I'm aware of. If it fails, it will need custom parts or as JP and JB have said,

Just a few shots of Minerva as the bottom paint goes on.

I like thé new Furuno With Cmap or you go with BG Zeus 3 S with avionics . I have both on board they are very good and far better than the previous generation . I have also an iPad which can work

Dear Members In the recent past I've had some problems with Furuno plotters (I've already replaced one of them) the speed doesn't stabilise either, the wind direction works bad and the Ais only work

Thanks Jean-Pierre, We replaced the furler on our Genoa with a Facnor, very happy with it. Just a matter of choice. Finding/fabricating parts for old models will become harder and harder. Sometimes

Thanks for that and you will note that the first sentence in the attachment when licking on More... reads "Mr. Vignando is the original manufacturer of the Amel SM 2000 Genoa Furler."

Hello guys, Be careful. My early super Maramu has a totally different system installed for Genoa furling. If mine lets me down, I would likely replace it with a new unit from Facnor. (as per Amel

Yes and yes. Best, CW Bill Rouse Amel Owners Yacht School +1 832-380-4970 | brouse@... 720 Winnie, Galveston Island, Texas 77550 www.AmelOwnersYachtSchool.com Yacht School Calendar:

Mark, I agree it might be helpful but the forum rules specifically prohibit "criticism of persons or businesses in which you may have experienced unsatisfactory results..." and I am being pretty

Hi Bill, I hope this finds you well. Do you know if the genoa rebuild kits are still available. While everything is working currently, it is all original from 1992. I'd like to obtain the 3 part

I ordered a 0311-201-001 dipstick and was invoiced for that number, and the bag stated that number, but the actual dipstick is a 3311-301-003. I was assured that they are the same, In any case, the

We experienced the opposite last summer. We were sitting very high on the water. I had removed additional chain and anchors from the stern locker and had placed them in one of the forward lockers (the

Yes Alan, I agree. In all my racing days we knew the best place for weight was central. Miimise weight in both ends. But we have a huge stern lazurette and voluminous lockers forward. Inviting weight