Paul, I bet some "certified electronic technician" was aboard and did something like "grounding and instrument." I have seen this more than once. And it is usually because someone is adding some

Not sure what you consider low wind speeds but we have not experienced inaccuracies at any speed. Ian & Margaret Loca Lola II SM153

Hello, I am planning to order new Hypalon RIB 250cm. Maine objective is to be able to put it in to aft storage (lazzarete) when on long passage. I can find the dimension of solid part of dingy but

Hello Joerg; Do you mind sharing the name of the Mastervolt dealer in Spain you worked with? How was your experience with the dealer? Mohammad and Aty B&B Kokomo Amel 54 #099

How accurate do you find the ultrasonic wind sensors? I read reports of them being not so good at low speed, is that BS? -- Paul Harries Prospective Amel Buyer

Interesting that there would be a permanent on circuit with a transformer. Would tend to make one kind of crazy

Bill Hall, The switches are original but they are working just fine. I believe Bill R’s and Mark’s explanation regarding the ‘permanent circuit’ explains why I was still seeing the leak with

Ian, Smart move. Forthe cost of the repair, replace it with something better J I’ve been suckered into two expensiveB&G repairs. No more! I have a goodfriend who also went this route and he

Yes, Ken wrote me when this happened and I stepped in and was in touch with QSails until they were shipped. Your order was delayed because of a supply chain issue with Dimension Polyant, complicated

Hello Jose, I too had delays in receiving my sails from QSails. I ordered a full set of Hydranet sails, ballooners and a storm sail so it was quite an expense. Initially I was very concerned when

I had 3 Mastervolt MLI5500 installed on my boat by the Mastervolt dealer in Spain. They were about E5000 a piece. Add to that installation which in my case included a MV Easyview monitor and

Paul, Bill beat me to it. As a first check, I would turn off the switch on the Sailor 24v to 12v Step Down Transformer and see if the Masse light still illuminates when you test it. If it does not,

Hi Paul and Bill, Am I wrong in thinking that the voltage readings are correct? Amperage through the bonding system would be a problem. My SM 37, has had varying anode lifetimes. Marinas and

Paul, There is a 24-volt wiring bus behind the wood panel directly above the nav tabletop labeled 24-volt Permanent. This is hot when the switches are off. The only thing connected to that bus should

Hi Greg, That was what I would have done had I gone internal but as I said I surface mounted "temporarily" and it was so satisfactory I left it as it was. I don't think anyone even notices the

Hi JB. Glad to help Kind Regards Danny Ocean Pearl

How old is the battery disconnect switch or is it corroded internally?

Almost since purchasing our boat, we had a small negative leak that was indicated by the Masse Light. The electrician in Martinique could not locate the source easily, but said that it was very small

After all the trouble and expense of trying to fix two B&G MHUs, I finally solved this problem by replacing it with an Airmar 220WX weather station.

The following files have been uploaded to the Files area of the main@AmelYachtOwners.groups.io group. /45-D01504-en Fimtec Technical Information.pdf By: Mark McGovern