I've taken it out to check how dirty my tank was. Very easy to do but I have no idea what the model number is. There are two inspection hatches on the top of the tank. It's the forward hatch with the

Joel, Bill pointed that out to me ,but what he sent and I read ,left me wondering if they were referring to using high pressure above the waterline,which they stayed several inches below. In any event

Dear Forum, I'm wondering which model level meter/sensor Amel used inside the diesel tank. I know it is far from accurate looking at gauge at several points of filling. I was wondering if the thing

Hi Pat. Before you paint the bottom or apply any coatings, be certain to have the bottom checked with a moisture meter over its entire surface. It states in the Amel owner’s manual in the third

Vic, I'm no expert, but here are my experiences. I've recently replaced a lot of the engine room hoses on Rascal due to rusted hose clamps, stiff hoses, and to simplify some non-Amel

Unfortunately, from Bitstorm website: “As of March 2020, Bitstorm made the decision to cease production of its high power Wi-Fi systems. A number of factors caused this decision and included

James, There was one area ,about 8 sq. inches where there must have been a void where the first or last layer of fiberglass was partially removed ,the manager said that sand blasting would have opened

Scott, my point was not the radiation pattern of your own antenna per se, the access point has a radiation pattern as well. It takes two to tango in this case as the communication is bi-directional,

Gerhard, I am talking about omnidirectional antennas, which I think you call "rod". They do look like a rod. Vertical Beamwidth depends on the dBi gain. If you have a 15dBi gain antenna, it will be

If you have a rod antenna it has horizontally 360 degrees but vertically a very small angle and never more than a few dregrees. 30 degrees are physically not possible. So this kind of antenna should

Thanks everyone for the comments. It seems the logical way to solve this is to isolate the antenna from anything connected to the bonding system. This is what I intend to do as the case is plastic and

Scott, A few things about this. The base of the antenna may be connected to the negative of the power-supply of the WiFi extender. If that is the case, isolate it from the mast. Second putting your

Pat, This sounds like an interesting option to me and apparently there was no damage done to your gel coat. I like the fact that you avoided using harsh chemicals. You also checked your boats

Scott, I hope you guys are safe and healthy. Since I am a simple person who enjoys simple explanations, let me jump in with what I think will help you. The Amel Bonding Checking System on your Amel

A few weeks ago I mentioned that I intended to have by boat sandblasted , I paid for it ,but they did something different,maybe better. I went to see what progress had been made on repairs . The

Hi all, This is really a question about bonding, which I'm very weak on. We have been using a Wirie Pro wifi extender on our A54 for over 2 years and while the Wirie didn't work that great, I

Thanks but I think you are looking for this video…. The other one was a narrowboat guy who seemed happy with his setup. https://www.youtube.com/watch?v=jgoIocPgOug Brent On Aug 17, 2020, 1:55 PM

A second vote for Mike Previti. He surveyed two of my previous boats, and when I spoke to him about my upcoming purchase of my Amel 54, he was very knowledgeable about them, and was able to describe

Je all , In the link you find a you Tube Video from victron , it explaniert what Happens Wien you London li battreis with a small ore wrang altinator Berry intresting

Hi, For the first time, I'm looking at replacing a lot of or ~all of the hoses/valves that deliver fresh or raw water in the engine room. Some of mine have become extremely rusted or are a bit split.