Congratulations! I love it! Do you, or anyone, know if the solution is feasible for a Super Maramu 2000? Any idea about the cost? It's a wonderful improvement, very well thought out. Thanks for

I'm living on my 55 right now which is in the water in jersey city, nj. I was away visiting family over christmas. I have a raspberry pi on my boat running the usual IOT stack

Hi Arno, I have everything hooked up now and want to upgrade everythings firmware which appears to need the installer password. If you can email it to me at billy at billynewport dot com I'd be

Super nice solution – well though out, well made. Sent from Mail for Windows 10

Here is another suggestion. The two Vacuum-Epoxy-Lightweight-Parts where made in Le Marin by ALIZE COMPOSITES (Manu). It is the same company made the not any longer existing mold for the hardtop. All

International Reps I spoke to advised that Brightside has been discontinued and now replaced by Toplac which is why you will see that sites like Amazon have it listed as CURRENTLY UNAVAILABLE and not

https://www.amazon.com/Interlux-Y4218-QT-Polyurethane-Fluid_Ounces/dp/B000XBD3RI?th=1&psc=1 Sent from my Galaxy

We used International Toplac Ivory with about 10% Toplac Cream as international no longer make Brightside. The mix was a very good max. We brought the Beugler tool but didn’t use it as we felt we

We have had a 200 liter fuel bladder made by nauta for many years. they made two types. The better one which we have has a nylon outer coating , brass connectors and hold down straps. We fill it and

Hi Dan, thank you for the info your structure looks great. Would you kindly send the phots directly to my email. matti.lohikoski@... When I try to download from the site, I get only 71k which is too

I uploaded photos of our canvas to the Photos section. Thanks, Dan Feierabend SM #86

Ww used Interlux Brightsides Hatteras White with a flattening agent. Very close match. Two coats. Looks great after three years. About 40 hours per coat. Be careful with the striping tool. Despite

Dear all, I finally made it to get my Beugler striping tool. Not easy since the California Branch does not even answer emails and the European branch is in the UK. So nowadays outside

14 days and 10 Jerry Cans should be more than plenty but I agree bladder should be fine. If you’re really concerned fill it with 10 gallons and move shake and squish vigorously then dump you should

Last year I received this sketch from Amel SAV. -- Jose Prieto SV Wayag, SM 323 Currently Alicante, Spain

Thanks to all for your advice, I have asked my boat sitter to trip them. Cheers, Paul S/Y Ya Fohi - Amel 54 #98 - Grenada

We refit ours. Easy and cheap. They look good. Victor SM314 Alendoy

I’d have to guess cleaning would not be necessary. The problems emanate from moist air getting in the tank. I imagine your bladder isn’t vented, and flattens as it empties? If so, there isn’t a

Many/most of us have a COVID related "change of plans" story, but ours included 28 days nonstop Panama to Nuku Hiva, 8 days in Nuku, then 14 days Nuku to Hawaii. We had been Caribbean based our first

Jérémy, I'll second Bill R.'s opinion, that TF Marine pump is top notch. Very expensive, and lasts forever. Replacing the original pump is usually done because fo the difficulty in parts sourcing.