Jan, ...for few days, grrr ! We are at Milos sailing Westbound to Cleopatra Marina Preveza. Let us see next year, you never know ;-)) Buon Vento Giovanni

i got an Icerette from Raritan this year. they have both 110v and 220v models. it is fantastic and makes delicious ice very fast. we keep it off and empty most of the time, then turn it on, first

I recently discovered that Amel has a repair kit for foils. According to someone who knows there is enough foil at the top when your Amel was made to cut about 6-7cm off the end twice. Now to the

Giovanni, we are arriving in Kilada on 11th, hope to launch on 17th and be afloat until 20th October, sailing at first in the Northern Cyclades and then wherever the wind takes us. Maybe our wakes

Great intel. Thank you all! Testing today. Porter Porter McRoberts S/V IBIS A54-152WhatsApp:+1 754 265 2206 Www.fouribis.net

Thank you for the suggestions. I know that both thermostats are OK, they open before the water boils. I will make the test of the sensor/gauge with boiling water to see if it is a measurement

Jose Alegria Amel55 #03-MERIT +351918663037 Josealegr@...

...perfect Ian ! In the while Alban from Amel Marin told me the same. Where are you ? We are saling Greek waters. Ciao Giovanni

Hi Giovanni , We took the sail off and disconnected the gearbox from the foil and then took the gearbox off the mast . This allowed the foil to drop down and the very bottom could then be gently

Dear Jan & Judy, Do you remember their procedure to do that ? (Sail removed, lift down gear ecc ?) After a saling around the world always with trade winds from port side, wrong side for furling,

Hi Courtney, After seeing Delos fixing his we hired a car and drove to Darte yesterday in Fort de France, Martinique. They will not have any until October. Looking for a compact unit 220V. As we are

Cheers Courtney Trippin 54 #101

Not sure what your "green zone" translates to in bars as I have a gauge with numbers and 60 bars +/- is where these operate (actually I usually get good tds at 850 psi / 58 bars). These pumps

Hi Giovanni, When we had the same problem after about 10 years and 50,000 miles the Amel team in Guadeloupe took about 2.5 cm off the bottom of the foil and drilled new holes. One day I shall go up

Hi to all, thanks to Duane Siegfri photos it was possible to see how the foil is connected to the furling gear shaft. Well, I suppose that my steel upper bolt has enlarged a little

Hi Porter, Both brass fittings have just been replaced on the pump by me, in and out a few times. The high pressure side broke off completely and the low pressure/inlet had a hairline crack. I only

Thanks Nick! I appreciate it. Yes. That’s the elbow. They have others in brass here too. They’ve worked up the pump with another brass one. And also used Teflon tape to seal the high pressure

Hi Porter, When I bought Amelia, the 160 litre per hour 220v watermaker produced a fine mist of salt water. It turned out to be that Brass Elbow between the CAT pump and the pressure bulb that you

Gary et all I’ve read this thread a bunch and it is super helpful. Thanks for all your insights, and others. I’ve removed our cat pump several times in the past week and it’s a real bear.

Hi José, Next time just remove the thermostat (don't put in the spare). It is not too important anyway as it simply allows the engine to come up to temperature more quickly by restricting the