Good day owner of a 1982 Maramu, came with an inflatable with rigid base 2.90 M lgth - already bulky on deck; cuts off view forward, unless propped on wooden berth similar to Delos arrangement (not

JP, I do not have your email address. If you will email me at brouse"at"gmail.com, I will reply with a DRAFT of my Amel School Book instructions for the washer removal. I believe that you will be able

Tom. If I believed the end cap is warped or the body is warped, I would take it to FKG and speak to Raul. He would be able to machine the pieces so they are flat. I would not go offshore with a known

JP, Yes, I do. I have photos and I am about to write instructions for my Amel School book. I will have it done in a day or so. Is that quick enough? CW Bill Rouse Admiral, Texas Navy Commander

I have never been to a yard where they routinely put sailboats into a travellift bow first. That is done stern first for a lot of reasons, but one of them is that putting the needed slack into

Does anyone know how to remove the clothe washer in the 54?

I would check with another motor rebuilder—that number seems very high, unless he is changing some gears. Fair Winds Eric Kimberlite Amel Super Maramu #376

Gary, To clarify what Alexandre meant. Here in the USA many pedestals have 2 30 amp sockets. Each is on a separate circuit. For example one 30 amp plug might be connected to the black , white and

Jay, Good luck with the motor...I am sure that you can get it repaired. Are you sure that it is the motor and not the cable? Also, with very few exceptions, I believe and I teach that when entering a

Try backing into the Travel Lift :-) Craig, SN68 Sangaris

Jay, Sorry, I can’thelp on an electric motor source but electric motors can normally be repairedby local companies. We had a main sail furling motor rebuilt by a local Floridarepair shop and

Paul, That 66b pump is a very good pump, lasting up to 10-12 years before needing a rebuild kit (from only Amel). The pump is no longer made, but when it was available, it cost about 500-600 euro. In

Good morning Bill, Just to add to the topic, here is the reply from: Shad Doughty Technical Service Representative 800.307.6702 direct technical@...     

Thank you Alan and Bill for your quick responses. Batteries were new last Summer and are currently on the charger. Bill, I agree with you that I most likely have the 66B as your attachment

One thing that caused my pump to run for lengthy periods was simply a kink in the intake hose. When the pump came one, the suction would squeeze it down enough to restrict the flow causing longer run

I attached the wrong page...here it is. Best, CW Bill Rouse Admiral, Texas Navy Commander Emeritus Amel School www.amelschool.com 720 Winnie St Galveston Island, TX 77550 +1(832) 380-4970

Gary and Alex, This really gets confusing. You are both right, sort-of. But, when marinas have 220VAC 60htz 50 amp connections available, you should use it to avoid potential mistakes...and you should

Hi Amels Owners, I have run into a bit of an issue with my headsail furling motor. At my local marina, the headstay needs to come off to accommodate the travel lift. After doing this several times the

Paul, It depends on what pump you have installed. Your Amel most likely came with a A.M.F.A. (Reya) #66B fresh water pump and attached stainless steel accumulator tank. If you have the original

Good morning Gary, Before I went to Tortola, I asked using that specific part to Marinco and was advised not to use this because of the Phase. Sincerely, Alexandre SM2K #289 NIKIMAT Island Water