Similar to Alan I will just report on our experiences with Emerek. Riza made us a set of Davits and sent them to me here in Brisbane. No problems at all and excellent pricing and service. After that

I cannot make any judgement about your experience. But my experience in dealing with EMEK has been fine. We had a complete davit arch shipped from Turkey to New Zealand without any problem Riza was

Hi Rafael, We have had this issue also. The cover /plug can be levered out with a screwdriver under the lip. The only way i found to stop it dripping was to put silicone RTV around it and push it back

Rafael: On my SM, some years ago the o-ring inside the cover had split. I purchased o-ring stock of the same diameter, cut it to size, and glued the ends with the best quality

Not a permanent solution as we haven't figured out how yet. But if you lift the grey plastic/composit on the out side up, clean it and the whole and replace it will be tight for a while. Annsofie &

Hello All, I have had in Turkey some Works done on my Amel. It was in Göcek, at EMEK Marina. At this occasion, the owner, told me, that he has a large stock of Amel-parts and can ship them

Hello everyone: the deck has a pass for the emergency tiller. I discovered a leak of water into the aft cabin, washing the deck. Two questions: Has any of you had this and how did you solve it? How do

Not sure why text is formatted with underline. It wasn't intended.

Removing the sink panel aids when pushing the unit back intoplace. With the sink panel removed, access is gained to the rear of the refrigeratorto ensure the long copper tubing is not pinched when

Hello Alexandre, Thanks for sharing. On Nr. 350, we did not have to execute step "remove the sink panel" in order to fully remove the fridge. We removed the fridge for cleaning in 2014 in Fort

Not from above. Joel was spot on. Really appreciated! Thanks Bro!

Adagio's fuel gauge was stuck on "Full" for a while so I pulled the sending unit out and found it broken. I tried to repair it, but decided against it as should the rod break free (again) I might

Ok, many thanks Alan. I'd better check my ground straps then as this is the first time ever that I have noticed any bits of rust on the keel stubs at all. Colin Island Pearl II, Amel 53 # 332 Gold

Hi Colin, Yes earlier this year we had the steel keel completely cleaned off and refinished, and then antifouled, but that wasn't because of rust, it was because we ran in to something last year and

Hi All We are on the hard for a few days and I have noticed small rust spots on the steel keel lower bulb/stub section only. Possibly around 20 or so very small rust spots no larger than perhaps the

Good afternoon, I just illustrated the “fridge removal”. I could feel more heat coming from the fridge’s compressor and after I defrost the it yesterday, the fan made a funny noise… So in

Hi stephanie IF you send me a mail I'll scan and send you the original compartimentation. Br Antonio Santorin 108 Vagabundo Roma Inviato da Yahoo Mail per iPhone

Good morning Peter, Can you describe the “unusual” noise? Does it sound like higher pitch? The last time mine failed it was actually the gear that were slightly worn out, putting a new set of

Does anyone know of Amel Super Maramu's for sale privately? We are in contact with a few brokers and ready to make some offers pending viewing. We were hoping to see an Amel before seeking to buy