Barry, I’m curious as to why they need replacing – UV damage? Should I be concerned about mine? Cheers, Paul S/Y Ya Fohi - Amel 54 #98 - Grenada

Hi Barry, I am looking on their website but can not find them. Do you know what they might be called? Nick

Hi Steve, All those screws removed, were they just holding the sound insulation in place? When I get a lot of water on the cockpit floor I get a squishy sound when I walk on it. I'm guessing that all

Thank you all for the recommendations. As usual, this group is a wealth of knowledge that I greatly appreciate. Luckily all the models recommended are local here. Force 10 is about $1,500 at one

DNA Marine in Italy sell them. Part A and Part B, top and bottom sold separately. ( dna-marine.it ) Best Barry

Peter, Remember that even if a diagram exists, the 54 rigging specs were changed twice during the production. The SM was the same throughout production.

To reuse the Dessalator screw-on fittings you will need a hose that is very similar to the hose Dessalator uses. I have done this with hose that I bought from Dessalator. I am sorry that I do not have

I need to replace some of the spray hood soap fasteners on Amelia. Any ideas where they can be sourced? Nick S/Y Amelia On the hard Kilada Greece AML54-019

I need to replace all my Lewmar arcylic lens on the 7 Lewmar hatches. I have measured the outside and they tally with Lewmar specs for the size 50,54,60,and 70. I measure the actual lens size and the

Hi All , As I have had a few requests for the pictures and info I will try to upload a file over the weekend for all to see. Best Regards Steve Bell s/y Dusk sm#378

Hi Dan Last year I repalced my 1989 Electrolux stove by a Force 10, 2 burner American Standard. I am very happy with this model. Very easy to install, same sice. Best Peter Jäger Wilson SM#003 (Sent

Hello Steve, Can you please send a set of the repair pictures to shipbldr2000@... ? Thank you! Charles

Does anyone have this diagram for a 54? Peter Forbes Carango Amel 54 #035 Hunkered down in La Rochelle.

Hello Soraya, I use a dairy industry line rated at 3000PSI. Complete with factory installed fittings. Cheers, Jean-Pierre Germain, SY Eleuthera, SM007, Opua, NZ jp.germain45@...

Hi Soraya, You can probably pick up the hose in any hydraulic shop. I use a hydraulic hose rated at 5,000 psi. Fair Winds Eric Amel Super Maramu #376

That looks very nice. Thank you

Hello, We are looking for the specs (type, inner/outer size, max pressure etc) of the high pressure hose HP between the HP pump and the 'pressostat' (pressure regulator?). We have checked online, the

Thank you Stefan, that is a start. Kind Regards Barry

I totally agree. Once you had GN Espace, I doubt if you will ever go back to anything else. GN Espace is a Yacht School Preferred Vendor.

GN Espace are very nice. However the price is eye-watering. About twice the price of Force 10. Also they use this (again expensive) system for putting things is in the oven that I did not really