Hi Jamie, Good to hear u make progress. What motor did u get? I use now different motors than in the start. With improved bearings. I use now also stronger motors of my own custom order but still

By now most are familiar with the problems many of us have experienced with the Flojet/Frigoboat refrigeration water circulation pumps. Several of us who have Amel 54's have noted the very short life

I Jose, Generally I Leave my Santorin in Cala Galera or on the river in rome in Nautilus Marina. Very professional and one of the best restaurant in Rome. Near airport too. You can get a quote calling

Hi José, on Elba Island I recommend following yards for winter storage. Very Professional services, but not only a

Dear Amellians I need advice from a marina between Livorno and Rome to leave MERIT during the winter period. Ideally a marina that has a nautical community during the winter period. Kindest

That should read “Diamond Hole Saw”!!!!!!

Hi Soraya, At the first sign the valve becomes sticky, we use vegetable oil to lube the valve. With the holding tank empty and the valve closed, remove the deck cap and pour about a 100ml of

Finally got to the aft head with the riser repair. The copper here was also corroded away with the riser pipe inside the tank completely separated. (Any leak between the tank and the head pump would

From the outside of the boat while sitting in your dinghy you may be able to use a grease gun and put grease on the exterior of the valve then operate it from the inside to provide some lubrication.

Eric, Please confirm me for 1 unit, per Bill's knowledge. Bill, thank you. Jim SM384 Sirena Azul Seattle

Hi Porter, We installed a Marco 12E. All functions of the system are integrated into the pump itself. Well built! Jean-Pierre Germain, SY Eleuthera, SM 007, Opua, NZ

Thanks for answer Porter! I corrosion X and slightly change the cutoffs?? What does it mean practically. What needs to be done? Regards Arthur

You can buy a new Sware D Pressure switch almost anywhere in the world, but adjusting it can be a challenge. Google for instructions to adjust...there may be a few good videos. That said, the problem

Arthur we have the same occurrences. I corrosion X and slightly change the cutoffs and were good for about 6 months. But I’d like to know a long term solution! Porter A54-152. IBIS. Excuse the

We have the Idromini Acb Waterpump from Gianneschi. Sometimes it will not stop, the pump continues. We have to stop it manually on the pressure switch.... I have pumped up to 2 bar and cleaned the

Jim, If original SM 384 has normally closed, part number 309-0295-01 Best, CW Bill Rouse Amel Owners Yacht School +1 832-380-4970 | brouse@... 720 Winnie, Galveston Island, Texas 77550

Eric, I won’t be aboard to tell witch model I have until 04 August. If ordering before then, then please cancel my order for 1 unit. Otherwise I’ll reply further on Wednesday. Thanks for doing

Hi David, Because of your remark I just remembered something about this. When I repopulated the PCBs with new LEDs I also replaced the resistors. When you buy this package from Amazon:

On my Santorin the return fuel pipe from the injectors comes off the engine and back to the tank. On top of the tank is the air vent pipe that is visible in the passage way heading out to the scuppers

Thanks Arno, Excellent information and advice, makes sense to me. I have only a very moderate knowledge of electronics and was wondering why the LEDs failed in the first place and how to prevent a