Hello Volker, unfortunately you will have to change the seals to remedy this problem. Normally when we change the seals we also change the wearable bushing. All available thrue Amel S.A.V. Santorin

Hi Volker, Amel uses now SAE90, 15/40 is also ok, but no ATF! ATF is used for the gearbox, not for the drive. herbert, SN120

Alan, good video! thx. SSB installation and troubleshooting is sometimes tricky. I made my engineer's degree in electronics and telecommunication and are an active HAM radio user since many years,

Hi Arnold, thanks for the Info! So far my plan is to suck out as much as I can from the reservoir and/or gearbox and refill with clean oil.... Wish me luck for good wind so the engine will not been

Hallo Volker, attached you will find the manual and drawing for the C-Drive!! The oil is the same as for engine 15/40!! You must lift out for repair the seal. Best Arnold SY Zephyr SM 203 Am

Dear Amel Owners, I bought my Santorin (027) 3 month ago and getting her ready for the first move - from the port I bought her to my home port in Langkawi/Malaysia. Its a trip of approx 1200 Nm - but

Herbert, Here is some good basic info regarding using an SWR meter... https://youtu.be/qSea5FjcTDE Cheers Alan Elyse SM437

Testing with SWR- Meter from exampel Diawa is an easy test or look for help by a local HAM-radio Club. Try to google your Location and Ham-radio Club. Wolfgang Do8ww SY Elise Amel 54#162

I would test the SWR (stand wave ratio) of your system. It tells you how much energy which is going out is reflected. With a device like this: (there are others which can do the

Joerg, * what cable did you use for connecting the antenna with the tuner? should be a GTO-15 and no coax / copper cable. This is sometimes the problem. * make sure that this cable is away from

Thanks very much everyone for responding. I had thought I would disconnect the tank from the common ships ground and connect it to the SSB ground. I have been checking my connections since the boat

Hi Frederic, Did amel supply these parts for you? I'm hoping to replace the same mounts in the coming weeks as the engine is out of our Mango. Thanks, Ellen

HF shall do no harm neither to the Amel bonding system nor to all connected metals, even if transmitting with high power. It is the DC connection that has to be avoided, and this DC connection will be

Hi Joerg I believe that it is hard to improve on a direct connection system using dynaplates. If the connections are good and the dynaplates are relatively clean then I am not sure that extending the

Hello Joerg, all the metal parts of your AMEL 55 (including your fuel tank) are connected together with the green/yellow wiring net and with the zinc anodes of your rudder EXCEPT the SSB

Heinz, I believe most of that area in an SM is a false floor that is glassed in above the actual hull. Bill--

I was suggested by an expert to line the entire floor of the stern locker with copper foil and then solder it to the ground of the antenna Fair Winds HEINZ Quetzal, Sm 2000, 292

Hello Bill, nothing to add so far. That's just a perfect information. Olivier

He all when the flap is not in stock by Amel , maybe you find it here Best Elja SY Balu SM 222 https://www.segelladen.de/Inhalt-untergruppen17/spiegeldurchfuehrung.htm Von meinem iPhone gesendet

On my boat 90% of Electric and electronic Problems are Connection Problems. This also applies to the SSB radio installation. I would check all the connections from start to end for corrosion and weak