Rink, Many thanks. Whereabouts exactly is the unit located? Do I need to open the windlass? Cheers, Paul S/Y Ya Fohi - Amel 54 #98 - Grenada

Alan, Many thanks. Are you able to confirm that the same one is used on the 54? Cheers, Paul S/Y Ya Fohi - Amel 54 #98 - Grenada

Hi Paul, There are different numbers showing up at the Forum. You can find the documents at the suppliers websitehttps://www.ifm.com/gb/en/product/IB5072 I ordered the IB5072 (EUR 79) and

I emailed Stephane and got the following response back. "Good Morning Billy, I am Ioera from POCHON PRO design office. On AMEL55, the standard inverter DC/DC is a MAGIC 24/12-20

Paul, Here's some info that may help you Cheers Alan Elyse Sm437

Hi Alex, the pump is not self priming so if the foot valve on the bottom of the suction pipe is not holding the water in column in the pipe the pump will act but not suck. If you grasp the suction

Hi all, I believe I need to get a replacement anchor chain counter sensor. I’m away from the boat and cannot find anything on the Lewmar online store so I would much appreciate if someone could

Alex, I have had this happen twice to the auto bilge pump when the hose drained whilst in the yard for an extended stay. The resolution was to allow the hose to fill with water from the fridges by

No that I think about it I have seen another refrigeration repair shop close to where Amel is. Cheers, Paul S/Y Ya Fohi - Amel 54 #98 - Grenada

Hi all, a bilge pump question on SM8 as our pump has been showing signs of weakness twice in one month. It keeps on pumping but nothing comes out. I've dismounted it but nothing looked wrong or

Was the Orion charger an upgrade? Check the battery. The start battery should not be discharged just because the start-battery-charger goes down. Unless there is a short somewhere. 1A. Replace the

Joerg’s advice is the first thing I thought of when reading the original post. The fuse size is not the problem. As in all things Amel, there is logic in why that particular fuse is 15 amps, even

David, don't forget, "before David." CW Bill Rouse

Hi again, Dave. When you say you've had a couple of cracks in your rub rail inserts, it sounds like you've got a rigid plastic insert. Eric mentioned that's what he had too. These new inserts are

Hi Dave, It sure quacks like the balooner halyard not being removed. Although you've not had the balooner up yourself, my guess is it was done by a prior owner and those were bent when you got the

OK, Pat, I’m in as well. I had a couple of cracks in my rubrail inserts previously, but the trip through the Erie Canal and 36 locks has been a little rough on the rubrail. And I accumulated

So... I returned to the boat to take a closer look at the roller furling swivel, which is down at deck level since the sail is not hoisted. The swivel turns freely, with no sign of jamming. And the

Thank you Bill, I have been dealing with Caraibe Marine and they are very helpful. I didn’t know that they would do gas pressure settings on fridges. I will see them this week. Best Barry

Happened to us early on as we didn't get the idea that the ballooner/spinnaker halyard has to remain quite tight and well out of the way (aft) of the spinning foil. A halyard wrap into the genoa will

I recommend that you contact the following in e Marin: Contact: Patrice FOUGEROUSE CARAIBE REFRIGERATION Port du Marin, Bassin N°1 Bl Allegre 97290 LE MARIN MARTINIQUE FWI patrice@...