Vi säljer Lady Annila, Amel Super Maramu 1998 Vi säljer Lady Annila, Amel Super Maramu 1998 For English, se below the pictures. Vi har beslutat oss för att ta

I have a much older model than you, but my wires come out the port side of the motor. Bill Kinney SM#160 Harmonie Highlands, NJ

Thanks Alexandre No hurry I cannot do anything for a few days because of my own work commitments. I need someone to put their hand behind the motor and see if the wires come out the port or starboard

Can you find your answer looking at the pictures on: http://nikimat.com/bow_thruster_overhaul.html I am super short on time, about to go to dentist appointment, then grocery shopping, etc. If it

Too late now, but you should have purchase a Multi System TV (Pal, Secam and NTSC). My TV and DVD/Blue ray readers are all Multi system as well as 50/60 hertz. Make sure your TV is capable of

I looked and I think mine are at the same place... I did not follow the wire (short on time because of work), but unless they are other solenoids, mine are there. Sincerely, Alexandre SM2K #289

We ordered the Samsung Smart tv on our new 55. It worked well in La Rochelle but gets no tv signal in US despite a large antenna. What kind of adapter or converter box will make it work? Thanks

Yes Andrew, you have the bow-thruster located in a watertight compartment, not allowing a watertight duct for the cables, but I think on Kent's (and most probably on all the SMs that don't have a

Hello Ian and Judy We have 450 W fitted by Emek. On Average in June we got 2.05 KWh/day, which I convert to about 83 Ah a day. We have been in the Ionian the whole of June. The lowest reading was 0,97

Hi I wonder if someone could verify something - I thing the engineer that refurbished the bow thruster motor may have made a mistake in where he has brought the motor wires out in relation to the

Not on our SM - they are in the bow thruster compartment high up on the port side bolted to the side wall. Andrew SM 472 Begin forwarded message:

In an SM, the bow-thruster solenoid switches are located at the front of the portside berth, under the berth board, behind a protection piece of plywood. Olivier

Masha Danki Andrew. I found it. Kent Curaçao

Ian and Judy, This is a very difficult question to answer since the truth is that it depends on your personal preference and the energy goals you are trying to accomplish using solar panels. We

Hi Ian & Judy We had Riza (Emek) make our davits and are completely happy with them as they are far nicer looking than anything else we have seen ever and the price was good too. I doubt you will have

Hi all solar users, We were planning to visit Emek in Turkey for one of their solar arches. Discretion being the better part of valour we have postponed that trip. We have so many photos of their

Andrew & Kent, I think mine is in a different place with access under the port berth, but I cannot get there right now...granddaughter, BeBe, is asleep on that berth. Will report back when the

Hi Kent It is bolted on the inside of the wall of the bow thruster compartment on the upper port side of the frame that supports the bow thruster assembly. Andrew SM 472

Kent, I think I know where it is, but I can't get there right now to verify it...Andrew, would you explain the location. Bill BeBe 387

Hi Bill, Where is the bow thruster solenoid? Thanks Kent SM243 Kristy